Attaching This Unit To A Wall - Panasonic SC-HTB500 Operating Instructions Manual

Attaching this unit to a wall

6
Thread a cord (not supplied) through the wall mount bracket.
≥ Use a cord which is capable of supporting over 20 kg.
7
Attach the lock pins into the wall mount bracket.
≥ The lock pins are designed to lock the wall mount brackets to the screws that this unit is attached to.
Hence, preventing this unit from falling off the screws.
≥ Keep the lock pins out of reach of children to prevent swallowing.
≥ Insert the lock pins as illustrated in the image below.
≥ Make sure that the lock pin does not get caught on the fall prevention cord.
A Do not insert the lock pin farther than this point.
8
Drive 2 screws (not supplied) into the screwing positions identified in step 4.
≥ Take care when fixing this unit to the wall. Always ensure that there are no electrical cables or pipes
in the wall before hanging this unit.
≥ Keep the screws out of reach of children to prevent swallowing.
≥ Be sure to use commercially available screws with nominal diameter of ‰4.0 mm suited to the wall surface material
(wood, steel frame, concrete, etc.) and also capable of supporting over 20 kg each for attaching this unit to the wall.
≥ The position in the wall where the screw is to be attached should be capable of supporting over 20 kg.
≥ Improper attachment may result in damage to the wall and this unit.
A Rear of this unit
B Fall prevention cord (not supplied)
A At least 30 mm
B ‰4.0 mm
C ‰7.8 mm to ‰9.4 mm
D Wall
E 5.0 mm to 6.0 mm
27