Attaching The Main Unit To A Wall - Panasonic SC-BFT800 Operating Instructions Manual

Attaching the main unit to a wall

Never use any other method than spacified to install.
To attach this unit to the wall, refer to the following instructions.
Installation work should never be done by any other than a qualified installation specialist.
Preparation
≥ To prevent damage or scratches, lay down a soft cloth and perform the
assembly on it.
≥ Keep the screws out of reach of children to prevent swallowing.
1
At the bottom of the main unit:
Detach the stand after removing the screws.
2
On the rear of the main unit:
Place the wall mount bracket by aligning
the holes in the wall mount bracket with the
projecting parts A.
3
Screw the wall mount bracket firmly into
place.
≥ Screw tightening torque: 100 N0cm to 120 N0cm.
≥ Repeat the steps above when installing the second wall mount
bracket.
4
Complete all the necessary connections to
this unit.
≥ Connect the AC mains lead to this unit, but do not connect it to the
household mains socket until the installation is completed.
5
Use the measurements indicated below to
identify the screwing positions on the wall.
A 62 mm
B 126 mm
C 103 mm
≥ Position the unit with at least 100 mm of space above the unit and
100 mm on either side of the unit. If not, it will not be possible to attach
the unit to the wall.
≥ Be sure that there is enough space above the unit and that the screw
hole positions are level with each other before drilling into the wall.
≥ Be sure to use a spirit level to ensure that both screwing positions are
horizontal to each other.
D 803 mm
E 128.5 mm
6
Check the strength of the installation
location.
≥ Check the wall strength at the 2 screwing positions. If the strength at
any of these positions is lacking, provide sufficient reinforcement.
– The position in the wall where the screw is to be attached should be
capable of supporting over 20 kg.
7
Drive 2 screws (not supplied) into the
screwing positions identified in step 5.
≥ Take care when fixing this unit to the wall. Always ensure that there
are no electrical cables or pipes in the wall before hanging this unit.
≥ Be sure to use commercially available screws with nominal diameter
of ‰4.0 mm suited to the wall surface material (wood, steel frame,
concrete, etc.) and also capable of supporting over 20 kg each for
attaching this unit to the wall.
≥ Improper attachment may result in damage to the wall and this unit.
8
Mount the unit securely onto the screws.
A Move the main unit so that the screw is in this position.
B Wall
≥ Be sure that both the wall mount brackets are securely attached to the
screws.
≥ If this unit is tilting forward, remove this unit from the screws and
adjust by tightening the screws.
9
Attach the cord to a wall with a screw (not
supplied).
A Rear of the main unit
B Fall prevention cord (not supplied)
C Screw eye (not supplied)
≥ Check the strength of the installation location. If the strength at any of
these positions is lacking, provide sufficient reinforcement.
A At least 30 mm
B ‰ 4.0 mm
C ‰ 7.8 mm to ‰ 9.4 mm
D Wall
E 4.5 mm to 5.5 mm
VQT2Z56
13