Remote Control Code - Panasonic SC-HTB500 Operating Instructions Manual

Changing this unit's
settings
Refer to "Troubleshooting" (
changing any of the following settings.
The settings remain intact even if you switch the
unit to standby mode.
A will blink green once when the setting is changed.
∫ VIERA Link
Changes to this setting become effective after
turning off and on all the connected devices.
Set "VIERA Link" to "Off".
Set "VIERA Link" to "Off" when you do not want to
use "HDAVI Control". (
Press and hold [INPUT SELECTOR] on this
unit and [BD/DVD] on the remote control for
more than 2 sec.
≥ When set to "Off", the ARC function is not
available. Be sure to connect using the optical
digital audio cable. (
Set "VIERA Link" to "On".
Press and hold [INPUT SELECTOR] on this
unit and [SOUND EFFECT] on the remote
control for more than 2 sec.
∫ TV Audio
Set "TV Audio" to "ARC Off".
Set "TV Audio" to "ARC Off" only when using an
optical digital audio cable with an ARC compatible
TV. ( 19, "Sound")
Press and hold [INPUT SELECTOR] on this
unit and [TV] on the remote control for more
than 2 sec.
Set "TV Audio" to "Auto".
Press and hold [INPUT SELECTOR] on this
unit and [CLEAR-MODE DIALOG] on the
remote control for more than 2 sec.
20
18) before
A
18, "General operation")
11)

Remote control code

When other Panasonic products respond to this
unit's remote control, change the remote control
code on this unit and the remote control.
Preparation
≥ Turn off all other Panasonic products.
≥ Turn on this unit.
Change the remote control to code 2:
1 Aim the remote control at this unit's remote
control sensor.
2 Press and hold [CLEAR-MODE DIALOG] and
[BD/DVD] on the remote control for more than
4 sec.
A will blink green once when the code of this unit is
changed.
≥ If the unit does not operate after changing the code, repeat
steps 1 and 2.
≥ To change the remote control to code 1, repeat the steps
above, but replace [BD/DVD] with [TV].
A