Panasonic SC-HT1500 Operating Instructions Manual page 3

STEP
∑ Surround speaker units
1
Attach the surround speaker to the small base.
≥There is no difference between the right and left speakers and bases.
1 Thread the speaker cable through the base and mount the
speaker on it.
Thread the speaker
cable through here.
Cable
Rear side of base
2
Connect the speaker cables.
3
Fasten the speaker cable.
∫For rear side of speaker
Press the speaker cable into the groove.
∫For rear side of base
1
2
Surround speaker assembly
∑ Small bases
Approx.
350 mm (13
Connect the speaker cables.
≥Twist off the vinyl ends of the speaker cables.
r:Copper
s:Silver
Press the speaker cable
and thread between the
hooks.
∑ Surround speaker cables
[10 m (33 feet) cable]
2 Secure the speaker to the base.
Ensure the screws are securely fastened
by lightly tightening the two screws
alternately until fully tightened.
The supplied stands are specially designed for
attachment to Panasonic SB-PS1500 surround speakers.
Only use as indicated in this setup.
25 /
q)
32
Push !
Rear side of speaker
2 Fit the speaker cable into the
base cover groove as far as
possible.
Cable
4
∑ Long screws
Cable
Rear side of base
If there is any excess speaker cable, pull lightly
on the speaker cable from the bottom of the base
to eliminate the excess, and press the speaker
cable into the groove.
Long screws