Specifications; Unpacking; List Of Contents; Instructions For Putting Into Use - Central Machinery 45861 Set Up And Operating Instructions Manual

SpeciFicatiOnS

Electrical Requirements
Lathe Type
Motor
Motor Speed
Spindle Speed
Spindle Taper
Spindle Bore
Chuck
Chuck Capacity
Tail Stock Quill Travel
Tail Stock Quill Taper
Tool Post Capacity
Swing Over Bed
Distance Between Centers 20"

unpacking

When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
proper lubrication is essential. To
be safe, and to become more familiar with
the Lathe, disassemble the lathe entirely,
then clean and lubricate each part with
white lithium grease before first use.

list of contents

description
9" X 20" Bench Lathe
4" 3-Jaw Chuck
Reverse Jaws For Chuck.
Chuck Wrench
Dead Center Mt#2
Dead Center Mt#3
Live Center
10-12 Open-End Wrench
14-17 Open-End Wrench
SKU 45861 For technical questions, please call 1-800-444-3353.
120 V~ / 60 Hz
Metal Cutting
3/4 HP
1790 RPM
120, 320, 420, 620,
1130 & 2000
MT-3
3/4"
3 Jaw
4"
1-3/4"
MT-2
3/4"
9"
Qty
1
1
3
1
1
1
1
1
1
description
17-19 Open-End Wrench
Round Nut Wrench 45-52
Tool Post Wrench
Hex Wrenches - 3, 4, 5, 6mm
Drive Belts
Threading Gear Set 28,30, 36,42,45 & 80T
Oil Can
Splash Guard
Operators Manual
inStructiOnS FOr
putting intO uSe
read the entire iMpOrtant
SaFetY inFOrMatiOn section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
FrOM accidental
OperatiOn:
turn the power Switch of the
tool to its "OFF" position and
unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.

Mounting

1. Unbolt and remove the Lathe from
the crate.
2. The Lathe will need to be mounted
to a surface capable of bearing the
combined weight of the Lathe and
intended workpieces. The surface
must be able to withstand the vibra-
Qty
1
1
1
1 ea.
2
1
1
1
1
tO prevent
SeriOuS injurY
Page 9