Speaker Setup - Panasonic SC-HT05 Operating Instructions Manual

1
Step
Front and surround speaker assembly
• To prevent damage or scratches, lay a soft cloth and perform assembly on it.
• For assembly, use a Phillips-head screwdriver.
1
Attach the pipe to the bases.
1
Thread the speaker cable through the base.
Groove Thread the speaker cable through here.
2
Insert the pipe.
2
Attach the stand to the speaker.
1 Ensure the stand is fastened on straight by lightly
tightening the top and bottom screws alternately
until fully tightened.
• There is no difference between the right and left
speakers and stands.
You can also attach to the upper rear of the speaker.
When attached to the upper rear, you can adjust the height of the speakers between 625 mm and 796 mm. When attached to the
lower rear, you can adjust the height of the speakers between 968 mm and 1138 mm.
(Speaker height adjustment
4

Speaker setup

Insert the pipe while
slightly pulling on the
speaker cable.
procedure 3)
è
(for SC-HT07)
3
Secure the pipe to the base.
Ensure the screws are securely fastened by lightly tightening
the left and right side screws alternately until fully tightened.
(The heads of the screws protrude slightly even if you have
fully tightened them.)
The supplied stands are specially designed for
attachment to Panasonic SB-FS927 front speakers
and surround speakers.
Only use as indicated in this setup.
Small screws
(included)
Large screws
(included)
For your reference
You can enjoy good acoustics by
adjusting the height of the front
speaker with the height of the
television so the center positions
of both are approximately the
same.
It is usually better to make the
surround speakers a little higher.