Monitor And Headphones Outputs; 2-Track Replay Input - SoundCraft MH2 User Manual

19
13
12
11
2
40

Monitor and Headphones Outputs

Separate level controls (9 & 10) are provided for engineer's monitor speakers and headphones.
The signal source for these outputs is common and can be selected from the post-fade MIX
signal (11), the Centre (mono) MIX signal (to both L and R outputs)(12), or the 2TK replay
inputs (13), and may be summed by simultaneous selection if required. These sources are
automatically overridden by an input or output solo signal. The level of the PFL signal can be
adjusted by +/-15dB using the PFL TRIM control (14).
The Monitor level can be contolled by the Centre Output master fader, for stage monitor
applications, by pressing the 'Use C Fader' button (2) adjacent to the rotary control. In this
case the Centre Output is fixed at unity gain (it is assumed that the C output will not be used in
18
the monitor application).
The stereo Monitor/phones signal can be summed to mono if required by pressing the MNO
button (15), and can be muted by pressing the MUTE switch (16).
The headphones output socket is a stereo 1/4" jack (17), discretely mounted in a recessed
socket in the fader panel fascia; the phones Volume control (10) is located adjacent to the
socket. The headphone amplifier has a high power capability: use caution when connecting
headphones to avoid damage to your hearing.
14

2-Track Replay Input

15
9
For replay of stereo tape, CD or Minidisc sources, a rotary level control (18) adjusts the signal
level from the balanced 1/4" jack stereo inputs. These can either be routed to the MIX bus with
the MIX switch (19), or monitored on the monitor/phones outputs as described above.
16
10
17