Table of Contents
Advertisement
Control guide
Ê
Buttons such as
function the same as the controls on the remote control.
Troubleshooting guide
Before requesting service, make the below checks. If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem,
consult your dealer for instructions.
• The disc isn't correctly set.
• The disc is scratched or dirty. (Tracks skipped.)
No play.
• There is moisture on the lens. Wait about an hour
and then try again.
• You may not be able to play MP3 if you have copied a
multi-session disc that has no data between sessions.
• When creating a multi session disc, it is necessary
MP3 cannot be read.
to close the session.
• The amount of data on the disc is too small. Set the
amount of data to greater than approximately 5 MB.
Sound is unfixed,
reversed or comes
• Check the speaker connections. (→ page 3)
from one speaker only.
• Noise may occur when playing MP3 if recording quality is poor.
• Keep this unit away from mobile telephones.
• Turn the volume up.
No sound or there is
• Switch off the unit, determine and correct the cause, then switch
a lot of noise.
the unit on. Causes include shorting of the positive and negative
speaker wires, straining of the speakers through excessive
volume or power, and using the unit in a hot environment.
Humming heard
• An AC mains lead or fluorescent light is near the cables.
during play.
Keep other appliances and cords away from this unit's cables.
A beat sound is
heard while receiving
• Turn the TV off or separate it from the unit.
a radio broadcast.
A low hum or noise
• Keep the antenna away from other cables and
is heard during AM
cords.
broadcasts.
• Keep the AM antenna away from the unit.
The picture on the
• The location and orientation of the antenna are
television near the set
incorrect.
disappears or stripes
• The TV antenna wire is too close to the unit. Separate
appear on the screen.
the antenna wire of the TV set from the unit.
• Keep the antenna away from computers, televisions,
DAB reception is
other cables and cords.
poor.
• Use an outdoor antenna (→ page 10).
Remote control
• Check that the battery is inserted correctly. (→ page 3)
• Replace the battery if it is worn.
doesn't work.
Standby/on switch [^] .................................................................... 4
Press to switch the unit from on to standby mode or vice versa.
In standby mode, the unit is still consuming a small amount of power.
The unit is in the standby condition (the [
AC mains lead is connected.
The primary circuit is always "live" as long as the AC adaptor is
connected to an electrical outlet.
Clock/timer adjust button [CLOCK/TIMER ADJ] ......................... 9
SLEEP timer button [SLEEP]......................................................... 9
CD program/clear, FM/AM/DAB preset button [PGM/CLEAR]....... 4, 5, 7
Play mode button [PLAY MODE] ......................................... 4, 5, 10
DAB primary/secondary select button [DAB, PRIMARY/SECONDARY] ...... 7
AUX button [AUX] ......................................................................... 10
Tuner/band select button [TUNER/BAND] .................................... 5
DAB button [DAB].......................................................................... 6
Volume buttons [VOL –, + VOL] ..................................................... 4
Extra D.Bass button [EXTRA D.BASS] ......................................... 9
Sound EQ button [SOUND EQ] ..................................................... 9
Album skip, FM/AM/DAB preset channel select buttons
[2, 1, u ALBUM i] ........................................................ 5, 7, 10
Display button [DISPLAY] .......................................................... 7, 9
Timer set/check button [TIMER SET/CHECK] .............................. 9
Numbered buttons [1–9, 0, 10] .................................................... 4
CD play/pause button [CD q/h] .................................................... 4
CD stop button [g] ......................................................................... 4
Live virtualizer button [LIVE VIRTUALIZER] ................................ 9
CD skip/search, FM/AM frequency select, DAB station tune,
time adjust buttons [u, i, –, +] ................................... 4, 5, 6, 9
DAB menu buttons [DAB, MENU, –, +, ENTER] ........................... 8
Standby indicator
When the unit is connected to the AC adaptor, this indicator lights up
in standby mode and goes out when the unit is turned on.
Remote control signal sensor
CD skip/search, FM/AM frequency select, DAB station tune,
FM/AM/DAB preset channel select buttons [u/–, +/i] ..... 4, 5, 6, 7
Tuning mode select button [TUNING MODE] ....................... 5, 6, 7
Display
Function indicators ................................................................ 4, 5, 6
The color changes depending on the source used.
DAB/DAB auto scan button [DAB] ............................................ 6, 7
CD open/close button [; OPEN/CLOSE]...................................... 4
No response even
• Use the following method to initialize the settings.
when button is
1.Remove the AC adaptor.
pressed.
2. While pressing [
I want to erase the
3.While continuing to press and hold [
memory and reset it.
"----------------" appears.
Display
• You plugged the AC adaptor in for the first time or there
– –:– –
was a power failure recently. Set the time. (→ page 8, 9)
• The total programmed play time is more than 200 minutes.
– – –:– –
Tracks can still be programmed and played.
• The number of programmed tracks is limited to 24.
PROGRAM FULL
No further tracks can be programmed.
NOT MP3 DISC
• A non-CD-DA or non-MP3 CD-ROM disc is inserted. Cannot be played.
ERROR
• Incorrect operation performed. Read the instructions and try again.
NO SERVICE
• The station is currently not broadcasting.
NO SIGNAL
• This station cannot be received. Check your antenna (→ page 3).
• Data broadcast being received over the DAB
DATA
broadcast signal. Cannot be used on this unit.
• The broadcast station being received cannot be
SCRAMBLE
accessed (E.g. pay per use etc.).
• Stations are not receivable. Check your antenna
Scan Failed.
and try Auto scanning (→ page 3, 7).
F □□
• Turn the unit off, disconnect the AC adaptor, and
（□□ stands for a number.)
consult your dealer.
• DAB station memory is full. Use the following
method to clear station memory.
1. Press [MENU].
2. Press [–] or [+] to select "STATION CLEAR".
STATION FULL
3. Press [ENTER]. "OK? Push ENTER" is displayed.
4. Press [ENTER].
Station memory is erased and the unit automatically
begins Auto scanning.
^
] indicator lights) when the
> =
^
/I ] on the unit, insert the AC adaptor.
^
/I ] ,
11
RQT7695
Hide quick links:
Advertisement
Table of Contents
