Panasonic SC-EN35 Operating Instructions Manual

SC-EN35 is used in the illustrations unless
otherwise mentioned.
Dear customer
Thank you for purchasing this product.
Before connecting, operating or adjusting this product, please read the instructions completely.
Please keep this manual for future reference.
These instructions are applicable to the following systems.
System
SC-EN35
Main unit SA-EN35
SB-EN35
Speakers
SB-EN35A
Troubleshooting guide
Before requesting service, make the following checks. If you are in doubt about any of the check points, or if the solutions indicated in the chart do not solve the
problem, consult your dealer for instructions.
No play.
MP3 cannot be read.
Sound is unfixed, reversed or comes
from one speaker only.
No sound or there is a lot of noise.
Humming heard during play.
A beat sound or noise is heard while
receiving a radio broadcast.
A low hum or noise is heard during AM
broadcasts.
The picture on the television near the
set disappears or stripes appear on the
screen.
Remote control doesn't work.
Display
--:--
PGM FULL
NO PLAY
ERROR
F76
USB SC-EN35
No response when [USB q/h] button is
pressed.
The USB drive or it's contents cannot
be read.
Slow operation of the USB flash drive.
"USB OVER CURRENT ERROR"
"NO PLAY"
Matsushita Electric Industrial Co., Ltd.
Web Site: http://panasonic.net
SC-EN33
SA-EN33
SB-EN33
SB-EN33A
• The disc isn't correctly set.
• The disc is scratched or dirty. (Tracks skipped.)
• There is moisture on the lens. Wait for about an hour and then try again.
• You may not be able to play MP3 if you have copied a multi-session disc that has no data between sessions.
• When creating a multi session disc, it is necessary to close the session.
• The amount of data on the disc is too small. Set the amount of data to greater than approximately 5 MB.
• Check the speaker connections. (➡ page 3)
• Noise may occur when playing MP3 if recording quality is poor.
• Keep this unit away from mobile telephones if the interference is apparent.
• Turn the volume up.
• Switch the unit off, determine and correct the cause, then switch the unit on. Causes include shorting of the positive and
negative speaker wires, straining of the speakers through excessive volume or power, and using the unit in a hot environment.
• An AC mains lead or fluorescent light is near the cords. Keep other appliances and cords away from this unit's cables.
• Switch the TV or other audio player off or separate it from the unit.
• Switch off the portable audio player connected to "MUSIC PORT".
• Keep the antenna away from other cables and cords.
• Keep the AM antenna away from the unit.
• The location and orientation of the antenna are incorrect.
• The television antenna wire is too close to the unit. Separate the antenna wire of the television from the unit.
• Check that the batteries are inserted correctly. (➡ page 2)
• Replace the batteries if they are worn.
• You plugged the AC mains lead in for the first time and there was a power failure recently. Set the time. (➡ page 6)
• The number of programmed tracks is limited to 24. No further tracks can be programmed.
• A CD-ROM disc that is not CD-DA or MP3 format is inserted. It cannot be played.
• Incorrect operation performed. Read the instructions and try again.
• There is a power supply problem. Consult the dealer.
• Disconnect the USB device and then reconnect it back. Alternatively, turn the unit off and then back on.
• The USB drive format or it's contents is/are not compatible with the system (➡ page 5).
• The USB host function of this product may not work with some USB devices.
• USB devices with storage capacity of more than 8 gigabytes may not work in some instances.
• Large file size or high memory USB flash drive takes longer time to read.
• The USB mass storage device rating exceeds 500mA. Disconnect the USB device. Turn the unit off and then back on.
• Check the content.
• Only MP3 format files can be played.

Operating Instructions

CD Stereo System
SC-EN35
Model No.
SC-EN33
E GN GCS
RQTV0167-2B
H0107FL2047
En