Table of Contents
Advertisement
∫ About the PTP connection
If the OS is "Windows XP", "Windows Vista"
or "Mac OS X", you can connect in PTP mode
if you set the camera to [
connect to your PC.
• Pictures can only be read on the camera.
They cannot be written to a card or deleted.
• When there are 1000 or more pictures on a
card, the pictures may not be imported.
• Do not use any other USB connection cables
except the supplied one.
• Do not disconnect the USB connection cable
while [ACCESS] is displayed.
• When there are many pictures on the built-in
memory or the card, it may take some time
to transfer them.
• You may not be able to play back motion
pictures on the built-in memory or the card
correctly when the camera is connected to a
PC. Import the motion picture files to the PC
and then play them back.
• If battery power is exhausted while the
camera and the PC are communicating, the
recorded data may be damaged. When you
connect the camera to the PC, use a battery
with sufficient battery power or the AC
adaptor (optional).
• If the remaining battery power becomes low
while the camera and the PC are
communicating, the status indicator blinks
and the alarm beeps. In this case, stop the
communication at once on the PC.
• When connecting the camera to a
"Windows 2000" OS PC with the USB
connection cable, do not replace the card
while the camera and the PC are
connected. The information on the card
may be damaged. Use "Safely Remove
Hardware" in the task tray on your PC
when replacing the card.
• Pictures edited or rotated with a PC may be
displayed in black in playback mode, multi
playback and calendar playback.
• Read the operating instructions for the PC.
• If a card is not inserted when the camera is
connected to the PC, you can edit or access
Connecting to other equipment
] mode and then
- 110 -
the pictures on the built-in memory. If a card
is inserted, you can edit or access the
pictures on it.
• You cannot switch between the built-in
memory and the card while the camera is
connected to the PC. When you want to
switch between the built-in memory and the
card, disconnect the USB connection cable,
insert (or remove) the card and then connect
the USB connection cable to the PC again.
• The message [PLEASE RE-CONNECT THE
PRINTER.] appears if you change the mode
dial to print mode [
connected to a PC. If connecting the printer
again, change the mode to a mode other
than [
] and then check that no data is
being transferred. ([ACCESS] appears on
the LCD monitor of this unit while data is
being transferred.)
] while this unit is
Advertisement
Table of Contents
