Connecting The Refrigerator To The Water Supply - Panasonic NR-B53V1 Operating Instructions Manual

Attaching the doors and front grille
1 Follow the steps for removing the doors and grille in their reverse order.
2 Tighten up fixing screws after checking that the door is parallel to the body and cold air does not
leak from around the gasket.
3 Tighten up screws to fix hinges using both the screwdriver (Phillips head) and hex wrench.
4 When installing the front grille and top hinge cover, be sure not to get the hoses and cord caught
in.
When attaching the front grille, insert the hoses into the guides inside the front grille.

Connecting the refrigerator to the water supply

Before connecting the refrigerator
A water pressure in the range of approx. 150 kPa to 700 kPa (22 psi to 102 psi) is must be to use the Ice/
Water dispenser. If the refrigerator is to be installed in a location where the water pressure is below approx.
150 kPa (22 psi), install a pressure pump to boost the natural water pressure.
Connect potable water supply only.
Parts required for the connection
Connection kit (accessory)
Hose connector (with strainer)
for G 3/4
Joint (with packing)
for G 1/2
Coupling hose connector Water filter
Installation
9