Cable Connections - Samsung SyncMaster 700DX-3 User Manual

• Do not use screws that do not comply with the
VESA standard screw specifications.
• Do not use screws that are longer than the stand-
ard length or do not comply with the VESA stand-
ard screw specifications. Screws that are too
long may cause damage to the inside of the prod-
uct.
• For wall mounts that do not comply with the VE-
SA standard screw specifications, the length of
the screws may differ depending on the wall
mount specifications.
• Do not fasten the screws too firmly. This may
damage the product or cause the product to fall,
leading to personal injury. Samsung is not liable
for these kinds of accidents.
• Samsung is not liable for product damage or per-
sonal injury when a non-VESA or non-specified
wall mount is used or the consumer fails to follow
the product installation instructions.
• Do not mount the product at more than a 15 de-
gree tilt.
• Always have two people mount the product on a
wall.
Product size in in-
ches
700DX-3
Warning / Caution
Do not install your Wall Mount Kit while your product is turned on. It may result in personal
injury due to electric shock.
Remote Control (RS232C)

Cable connections

interface
pin
Bits rate
Data Bits
Parity
Stop Bits
Flow control
Maximum length
• Pin assignment
Introduction
VESA screw hole specs (A
* B) in millimeters
800.0 mm × 400.0 mm
RS232C(9 pin)
TxD(No.2) RxD(No.3) GND(No.5)
9600 bps
8 bit
None
1 bit
None
15 m (only shielded type)
Standard Screw Quantity
M8 4