Fitting The Battery Pack; Setting Up The Handset For Use - Gigaset SL565 User Manual

Gigaset SL565 / GBR PTT / A31008-M1715-L111-2-7619 / starting.fm / 24.10.08
First steps
Reception strength:
The display shows the quality of the radio
contact between the base station and
handset:
Good to poor: Ð i Ñ Ò,
u
No reception: | flashes.
u
Connecting the base station
¤
First connect the mains adapter and
then the phone jack as shown below-
and place the cables in the cable
recesses.
1
1
1 1
1 Back of the base station (detailed view)
2 Mains adapter 230 V
3 Phone jack with phone cord
Please note:
u
The mains adapter must be always
connected, as the phone will not oper-
ate without mains connection.
u
If you buy a replacement phone cord
from a store, ensure that the phone
jack is connected correctly.
Correct phone jack assignment
3
2
1
6
2
3
1 unused
4
2 unused
5
3 a
6
4 b
5 unused
6 unused

Setting up the handset for use

The display is protected by
a plastic film. Please
remove the protective
film!

Fitting the battery pack

Caution:
Use only the rechargeable Gigaset Communi-
cations GmbH * Original battery pack
(page 58). Never use a conventional (non-
rechargeable) battery pack, as this may cause
significant damage to health and property. For
example, the outer casing of the battery pack
could be destroyed or the battery pack could
explode. The phone could also malfunction or
be damaged as a result of using batteries that
are not of the recommended type.
* Gigaset Communications GmbH is a trademark
licensee of Siemens AG.
¤
Insert the battery pack at an angle from
the right introducing the lugs into the
cavity first.
¤
Then push the casing from the top,
until the retaining clip on the side of
the battery pack clicks securely into
place in the casing.
Please note:
You must press the retaining clips down in
order to remove the battery pack.