Specifications; Instructions For Putting Into Use - CEN-TECH CEN - TECH 66550 Set Up And Operating Instructions Manual

SPECIFICATIONS

CAMERA
Total Pixels
Modulation Type
Bandwidth
Power Supply
MONITOR
LCD Screen Type
Effective Pixels
Electrical Input
Adapter Input
Operating Temperature +14°F~+122°F
Operating Humidity
uNPACKINg
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at the number shown on the
cover of this manual as soon as possible.
INSTRuCTIONS FOR
PuTTINg INTO uSE
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Functions
This mini water resistant camera with
3 ft. flexible tubing can be used to view
hard to reach locations while displaying
real-time video images on the 2.4" Monitor.
May be used for a variety of applications
SKU 66550
704x576 (PAL);
712x486 (NTSC)
FM
18MHz
4 AA batteries
2.36"TFT-LCD
480x240
8-24 VDC / 450mA
120 V~ / 60 Hz
15~85%RH
For technical questions, please call 1-800-444-3353.
including HVAC inspection, automotive/
boat/aircraft inspection, cable routing, etc.
ACCIdENTAl OPERATION:
Turn the Power Switch on the
Control handle and Monitor to
"OFF" position and unplug
the Adaptor from its electrical
outlet before performing any
adjustments, inspection,
maintenance, or cleaning
procedures.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Parts Diagram near the
end of this manual.
Inspection Camera Set up
1. To install Batteries:
a. Remove screw and cover on bottom
of Control Handle (1).
b. Slide Battery Compartment out of
Control Handle (1) and insert four AA
batteries.
c. Reinstall battery compartment and
cover. Secure with screw.
Keyed ends
Camera
Knurled Knob
2. To attach Camera (2) to Control
Handle (1):
a. Align keyed ends of Control Handle
with cable end of Camera.
TO PREVENT
INjuRY FROM
Control
Handle
Page 6