Troubleshooting; Please Read The Following Carefully - CEN-TECH CEN - TECH 66550 Set Up And Operating Instructions Manual

Problem
Tool will not start. 1.
2.
Monitor will not 1.
charge.
2.
Image too dark or 1.
light.
2.
Follow all safety precautions whenever diagnosing or servicing the
tool. disconnect power supply before service.

PlEASE REAd ThE FOllOWINg CAREFullY

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLy
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLy. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANy REPRESENTATION OR WARRANTy OF ANy KIND TO THE BUyER THAT
HE OR SHE IS qUALIFIED TO MAKE ANy REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
qUALIFIED TO REPLACE ANy PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR ExPRESSLy STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE
UNDERTAKEN By CERTIFIED AND LICENSED TECHNICIANS, AND NOT By THE BUyER. THE BUyER
ASSUMES ALL RISK AND LIABILITy ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION
OF REPLACEMENT PARTS THERETO.
SKU 66550

Troubleshooting

Possible Causes
Monitor not charged.
Batteries need changing.
Cable not attached properly.
Adapter not connected to
power.
LEDs near camera need
adjustment.
Monitor display needs
adjustment.
For technical questions, please call 1-800-444-3353.
likely Solutions
1. Charge Monitor.
2. Replace batteries in Control Handle.
1. Make sure Adapter Cable is connected
between Monitor and Adapter.
2. Make sure Adapter is securely plugged into
wall socket.
1. Use dial on Control Handle to adjust
brightness of LEDs.
2. Use Contrast and Brightness buttons on
Monitor to adjust image.
Page 10