Safety Precautions The following safety precautions must be taken when using your air cleaner. The air cleaner must be installed in accordance with national wiring regulations and safety regulations wherever applicable. Some installation locations may require installation of a short circuit breaker or grounding. If the supply cord is damaged, it must be replaced by a specialist or service person.
View of the Unit Unit Outer air flow blades (up/down orientation) Inner air flow blades (right/left orientation) Air outlet Filter reset button Switches for setting sensitivity & Cleaning cycle Pollution detection sensor Air filter Air inlet Ionizer filter Deodorizing filter(Carbon filter) How to open the front grille Hold the upper part of the grille, then pull it slightly...
Control Panel You can operate the air cleaner with the control panel when you do not wish to or cannot operate the air cleaner with a remote control. Clean level display Deodorizing indicator Automatic mode indicator Timer setting Fan speed Grille open indicator Cleaning the deodorizing filter...
etting Started You have just purchased an air cleaner and it has been installed by your installation specialist. Your Owner’s Instructions contain valuable information on using your air cleaner. Please take the time to read them as they will help you take full advantage of the unit’s features.
Inserting the Remote Control Batteries You must insert or replace the remote control batteries when : You purchase the air cleaner The remote control does not work correctly Use two AAA, LR03 1.5V batteries. Do not use old batteries or different kinds of batteries together. Batteries may be completely discharged after 12 months, even if they have not actually been used.
Selecting the Automatic Operating Mode You can start the air cleaner in the Automatic mode from your remote control. In the Automatic mode, the optimum fan speed is selected automatically. If necessary, press the (On/Off) button. Result: The DEODO. and AUTOMATIC indicators on the unit come on. The air cleaner starts up in the Automatic mode.
Adjusting the Fan Speed Then, the control In this case... Press... panel will show you... You wish to clean the air quickly High in your room. There is tobacco smoke or dust Medium in your room. When you want to clean the air lightly at ordinary times.
Adjusting the Air Flow Direction Vertically You can adjust the position of the outer air flow blades on the unit, thus increasing the efficiency of the air cleaner. Adjust the outer air flow blades to the desired position, by pushing them upwards or downwards.
Setting the Timer The timer enables you to set the air cleaner to switch off automatically after a given period time, by pressing a button. Press one or more times until the desired period is displayed: Result: Each time you press , the unit beeps.
Setting the Sensitivity & Cleaning Cycle You can set the sensitivity of the pollution detection sensor and cleaning cycle of filters. Turn the air cleaner off, then open the front grille. Set the sensitivity by adjusting the sensitivity switch. (Sensitive) : The sensor senses minute particles and tobacco smoke.
Cleaning Your Air Cleaner Be sure to clean the filters periodically to maintain the air cleaner in the best condition for a long period of time. When cleaning your air cleaner, turn it off and pull out the power plug. Open the front grille, then pull out the air filter.
Page 15
To Clean the Ionizer Filter flickers, clean the Ionizer filter. Open the front grille, then pull out the Ionizer filter by using the filter handle. Dissolve an alkaline detergent in tepid water, then put the filter in the water for 30 minutes. Do not handle the detergent with bare hands.
Page 16
Cleaning Your Air Cleaner(cont.) To Clean the Deodorizing filter flickers, clean the deodorizing filter. Open the front grille, then open the case of the Ionizer filter. Pull out the deodorizing filter located at the rear of the Ionizer filter. Clean the filter by shaking it in tepid water. Dry the filter in the shade, then insert the filter into the original position.
Solving Common Problems Before contacting an authorized service center, perform the following simple checks. They may save you the time and expense of an unnecessary call. PROBLEM EXPLANATION / SOLUTION Check that the plug fuse used for the air The air cleaner does cleaner has not been triggered.