Panasonic Viera TX-L32G10B Operating Instructions Manual page 75

Problem
Sound is unusual
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
The TV does not switch On
The TV goes into
"Standby mode"
The remote control does not work
or is intermittent
There may be red spots, blue
spots, green spots and black
spots on the screen
The LCD panel moves slightly
when it is pushed with a finger
Clattered sound might be heard
An error message appears
●
Set the sound setting of the connected equipment to
"2ch L.PCM".
●
Check the "HDMI1 / 4 Input" setting in the Sound Menu. (p. 31)
●
If digital sound connection has a problem, select analogue sound
connection. (p. 70)
●
Check the HDMI cable is connected properly. (p. 66)
●
Turn the connected equipment on and then switch the TV on.
(p. 61)
●
Check an input signal from the equipment. (p. 72)
●
Use an equipment compliant with EIA/CEA-861/861B.
●
Press and hold the standby On / Off switch on the remote control
for about 1 second if Power LED is red.
●
Check the mains lead is plugged into the socket outlet.
●
The fuse in the mains plug may have blown. Replace it with one of
an identical rating (p. 4).
●
Off Timer function is activated.
●
The TV enters "Standby mode" about 30 mins. after analogue
broadcasting ends.
●
Are the batteries installed correctly? (p. 6)
●
Has the TV been switched On?
●
The batteries may be running low. Replace them.
●
Point the remote control directly at the front of the TV (within a 30
degree angle of the front of the TV).
●
Situate the TV away from sunshine or other sources of bright light
not to shine on the TV's remote control signal receiver.
●
This is a characteristic of liquid crystal panels and is not a problem.
The liquid crystal panel is built with very high precision technology
giving you fine picture details.
Occasionally, a few non-active pixels may appear on the screen as
a fixed point of red, green, blue or black.
Please note this does not affect the performance of your LCD.
●
There is some flexibility around the panel to prevent damage to the
panel.
●
The panel might move slightly when it is pushed with a finger, and
clattered sound might be heard. This is not a malfunction.
●
Follow the message's instructions.
●
If the problem persists, contact the authorized Service Centre.
Actions
75