Registering The Handset To The Base Station - Siemens Gigaset AL18H User Giude

Registering the handset to the base station

Before you can use the phone, you must first register the handset to the base station.
The actual registration procedure will depend on the type of base station.
Automatically register the AL18H handset to the Gigaset AL180/AL185 base station
V
Put into base
MENU
V
Registering
Manually registering the AL18H handset
You must activate manual registration of the handset on both the handset and the
base station.
1. On the handset:
MENU
¢
Enter the base station system PIN (default setting: 0000)
V
Registering
2. On the base station: Within 60 sec. of entering the system PIN, press and hold the reg-
istration/paging key (min. 3 sec.). See also the user guide belonging to the base station.
After successful automatic or manual registration, the idle display is shown:
V
INT MENU
The handset is assigned the lowest unassigned internal number (1–4). If more than one
handset is registered to the base station, the internal handset number appears in the top
left of the display, e.g. 2. If the internal numbers 1–4 are already assigned to other
devices, the number 4 will be overwritten.
Please note
Only place the handset in the base station or charging cradle that is intended for it.
5
¤
Place the handset with
the display facing up in
the base station.
The handset registers automatically.
Registration can take up to 5 minutes.
Do not remove the handset from the
base station during this time.
¢ ¢ ¢
Settings OK
The registration screen is displayed.
Charge status of the batteries:
= e V U
–
=
– flashes: batteries almost flat
e V U
– flashes: charging
¢ ¢
Handset OK Register HS
¢
.
OK
(flat to full)