Initial charging and discharging of the batteries
The correct charge level can only be displayed if the batteries are first fully charged and
Place the handset in the base station or charging cradle for eight hours.
Then remove the handset from the base station or charging cradle and
do not replace it until the batteries are completely discharged.
After the first battery charge and discharge you may replace your handset in its
base station or charging cradle after every call.
Always repeat the charging and discharging procedure if you remove the batteries
from the handset and reinsert them.
The batteries may warm up during charging. This is not dangerous.
After a while, the charge capacity of the batteries will decrease for technical rea-
Setting the date and time
Set the date and time so that the correct date and time can be assigned to incoming calls,
and so that the alarm can be used.
(enter the day, month and year in 6-digit format)
(enter hours and minutes in 4-digit format)
(press and hold to return to idle status)
When entering the time and date, you can move the position of an entry to the left
or right by pressing the control button up or down.
Display in idle status
Once the phone is registered and the time set, the idle dis-
play is shown as in this example.
Activating/deactivating the handset
Press and hold the
If you place a deactivated handset in the base station or charging cradle, it will automat-
Your phone is now ready for use!
If you have any questions about using your phone, please read the tips on troubleshooting
("Questions and answers"
key to activate or deactivate the handset.
page 9) or contact our Customer Care team
OK (display message: Saved)