Setting The Channels And Clock - Panasonic DMR-EX77B Operating Instructions Manual

Setting the Channels and Clock

Preparation:
 Turn on the mains for the television
(and connected equipment) and select
the appropriate AV input to suit the
connections to this unit.
 These are the first settings you make upon
buying the unit. You don't need to make
these settings again.
DVD
¦ to turn the unit on.
DVB Auto-Setup starts. The unit will search
for the terrestrial digital channels. This takes
about 5 minutes.
– TV channels are sorted and stored in
channel numbers order sent by the
broadcasters and cannot be changed.
Power Save Function:
,  to select "On" or "Off"
then
OK
– Set to "On" to reduce power
consumption in standby mode.
– Refer to the following chart for the Power Save function features
when the unit is turned off.
Power Save
Power consumption
Watching the picture from the
satellite receiver connected
to the AV2 input terminal
Startup time
*
e.g., TV Guide is displayed within 1 second after [GUIDE] is pressed.
When setup has completed, the confi rmation screen appears.
OK
The Owner ID settings screen appears.
 and press the numbered buttons to enter
your choice of a 4-digit PIN number.
Make a note of the PIN number (don't
forget), as it is not possible to return to
the factory preset.
to store the PIN number.
OK
12
RQT8866
TV's remote control
DVB Auto-Setup
Please wait! Ch 21
Prog. Channel Service Name
23
1 BBC ONE
2 23 BBC
RETURN: to cancel
RETURN
Power Save
On
Off
On: Minimise standby power
consumption, without
Quick Start function and
AV2 loop-through in standby.
SELECT
Off: With Quick Start
function and AV2 loop-through
OK
RETURN in standby.
On Off
[EX77] Approx. 16 W
Approx. 2 W
[EX87] Approx. 17 W
Can not do Can do
Not quick Quick*
Owner ID
PIN number
Name
House No.
Postcode
RETURN
RETURN : leave
SELECT
68
Net ID TS ID Quality
12302 12289 9
12302 12289 9
STATU

10
OPTION
11
Tips
To abort Auto-Setup
Press [RETURN].
 If the unit displays "No stations found !"
Press [] to select "No" and press [OK].
Go to step . After you have performed
steps -, turn off the unit and confi rm
the cable or aerial input is connected to
the RF IN terminal. Restart the Auto-
Setup again (
 If the clock setting menu appears or
the clock is not correct, set the clock
manually (
Restarting the Auto-Setup (
 When turning on the Power Save
function, if the unit is turned off, unit's
display is also turned off.
To correct the PIN number
1. Press [, ] to select the digit.
2. Press the numbered buttons to enter
the digit.
____
DVD
TV
¦
¦
VOL
CH
DRIVE
A A AV
PA P P GE
2 3
1
CH
4 5 6
PROG/CHECK
8 9
7
MANUAL SKIP
DELETE INPUT
0
SELECT
SKIP
SLOW/SEARCH
PA P P USE PLAY/x1. A A 3
STOP
A A S EXIT
OK
RETURN
CREAT A A E
CHAPTER
63).
13).
63)