Resetting The System; Default Receiver Settings - Pioneer VSX-C501-S Operating Instruction

Using other functions
2 To switch SR+ mode on/off, press RECEIVER and
TV CONTROL INPUT simultaneously.
The front panel display shows the new setting; SR+ ON or
SR+ OFF.
Note
• The automatic volume muting feature is enabled
separately; see SR+ mode for Pioneer plasma displays
on page 36. (You can also use the System Setup
menu to switch the SR+ mode of the receiver.)
• If you disconnect the SR+ cable or switch the plasma
display off while SR+ is on, the receiver will
automatically revert to SR+ OFF.
Caution
• When the receiver is connected to a plasma display
using an SR+ cable, if the plasma display is switched
off, you cannot use the remote to control the receiver.

Resetting the system

Use this feature to reset the system to its factory default
settings.
RECEIVER
RECEIVER
SLEEP
DVD
INPUT VIDEO
CH SELECT
AUTO STEREO
SOUND
MODE
MUTE
MCACC
SETUP
DTV MENU
TOP MENU
ST
AUDIO
SBch MODE
RETURN BAND
1 Press RECEIVER to switch the receiver into
standby.
2 Press MCACC SETUP and SYSTEM SETUP at the
same time.
The display prompts you to confirm.
3 Within 5 seconds, press LEVEL –.
The display shows OK?.
4 Within 5 seconds, press LEVEL +.
The display shows OK and the receiver should now be
reset.
Note
• If the receiver is disconnected from the power outlet
for more than a month it will reset to the default
settings.
• The above reset doesn't affect the presets that you
have programmed into the remote control (see Using
the remote control with other components on
page 38).
TV/SAT DVR/VCR
FRONT FM/AM
LEVEL LEVEL
TEST TONE
ADVANCED
SURROUND
SURROUND
SIGNAL
DIALOG SELECT
MASTER
VOLUME
SYSTEM
SETUP
TUNE
T.EDIT
MENU
ST
ENTER
GUIDE
SUBTITLE
TUNE
DIMMER
DTV ON/OFF DTV INFO
A

Default receiver settings

The table below shows the factory default settings. When
you reset the system, the receiver reverts to these
defaults:
Setting type Default setting
Input DVD
– – – dB (no sound)
Master volume
Listening mode AUTO (all inputs)
STEREO (all inputs)
Listening mode (w/
headphones)
Sound mode OFF
OFF
Dialog
Surround Back ON (when speaker is
Channel mode connected)
Input signal select AUTO
Speakers (front, Automatically sensed
center, surround,
surround back) setting
200 Hz
Subwoofer setting
LFE Attenuator 0 dB
Front left/right: 2.0 m
Speaker distance
settings Center: 2.0 m
Surround left/right: 2.0 m
Surround Back: 2.0 m
Subwoofer: 2.0 m.2.0 m
Dynamic Range OFF
Control
ch1
Dual Mono
Input Attenuator OFF (all inputs)
DVD(TV/SAT) COAX DVD
jack assignment
TV/SAT(DVD) OPT1 TV/SAT
jack assignment
Channel levels Front: 0 dB
Center: 0 dB
Surround: 0 dB
Surround Back: 0 dB
Subwoofer: 0 dB
OFF
SR+ mode
Note
• The default settings for the remote control to control
other components can be found in Using the remote
control with other components on page 38.
08
Page ref.
Page 27
Page 28
Page 28
Page 28
Page 29
Page 32
Page 34
Page 35
Page 35
Page 35
Page 35
Page 36
Page 36
Page 36
Page 36
Page 37
Page 32
33
En