Correcting Distorted Sound; Resetting The Audio Functions - Pioneer DVH-P5950MP Operation Manual

Operating this unit
1 Press FUNCTION to select TV.
2 Press c or d to select an appropriate
TV signal.
NTSC—PAL—SECAM
Note
About your country TV signal, consult with your
nearest Pioneer dealer.

Correcting distorted sound

Only when the multi-channel processor (e.g.,
DEQ-P7650) is connected to this unit, you can
operate this function.
You can minimize distortion that may be
caused by the equalizer curve settings.
Setting an equalizer level high can cause dis-
tortion. If high sound is crippled or distorted,
try switching to LOW. Normally, leave the set-
ting at HIGH to ensure quality sound.
1 Press FUNCTION to select D.ATT.
2 Press c or d to select LOW or HIGH.

Resetting the audio functions

Only when the multi-channel processor (e.g.,
DEQ-P7650) is connected to this unit, you can
operate this function.
You can reset audio functions other than the
following settings.
! Volume setting (refer to Adjusting the vo-
lume on page 14)
! Listening position setting (refer to Using
the position selector on page 68)
! Fader/balance setting (refer to Using bal-
ance adjustment on page 67)
! SLA (source level adjustment) setting (refer
to Adjusting source levels on page 70)
! Dynamic range control (refer to Using the
dynamic range control on page 69)
! Direct control setting (refer to Using the di-
rect control on page 70)
! Down-mix setting (refer to Using the down-
mix function on page 69)
1 Press FUNCTION to select A.RESET.
2 Press a to display RESETOK?.
# To cancel resetting the audio functions, press
BAND.
3 Press d to display REALLY?.
# To cancel resetting the audio functions, press
BAND.
4 Press a to reset audio functions.
COMPLETE appears in the display.
Section
03
51
En