Panasonic KX-TG8621E Operating Instructions Manual page 67

TG862xE(e).book Page 67 Thursday, March 17, 2011 11:40 AM
Using Bluetooth devices
Problem Cause/solution
I cannot copy L Confirm that your mobile phone supports Bluetooth
phonebook entries
from my mobile
L Confirm that your mobile phone supports the Object
phone.
L If your mobile phone is already connected to another
L Turn your mobile phone off, then turn it on and try
I cannot have a L Your Bluetooth headset is not registered. Register it
conversation using
the headset.
L Turn your headset off, then turn it on and try again.
Noise is heard during L A Bluetooth headset can communicate with the
a call on the headset.
I cannot connect my L Confirm that your headset is turned on.
headset to the
L If your headset is already connected to another
handset.
L The headset is not registered to the handset. Register
L Confirm that the Bluetooth setting of your handset is
Your headset L Press {ic} on the handset to hang up.
automatically
connects to an
outside line when
turning it on.
Some headset L The handset does not support enhanced features such
enhanced features
are not available.
An error tone is heard L The bluetooth feature cannot be accessed immediately
when I try to program
the Bluetooth feature.
L The headset has not been connected to the handset
Helpline Tel. No.: U.K. 0844 844 3898 Ireland 01289 8333
wireless technology.
Push Profile (OPP) or Phone Book Access Profile
(PBAP) specification.
Bluetooth device such as a Bluetooth headset, turn it off
or disconnect it from your mobile phone.
again.
(page 57).
handset within a range of approximately 10 m. The
connection may be subject to interference from
obstructions such as walls or electronic devices. Move
closer to the handset.
Bluetooth device such as your mobile phone,
disconnect the headset from your mobile phone, then
perform the connecting procedure from the handset.
the headset (page 57).
turned on (page 55).
as Last number redial or Call reject.
after turning on the handset. Wait a few seconds and try
again.
yet, even though you performed the connecting
procedure setting. Wait a few seconds and try again.
Useful Information
67