Panasonic Toughbook CF-48 Series Reference Manual page 55

Dealing With Problems (Advanced)
Starting Up
Windows 98 Windows 2000
When resuming from the
standby or hibernation
mode, does not ap-
pear even if a password
has been set in the Setup
Utility
Battery Indicator
The red indicator lights.
Repeated beeping sound
while the computer is in
use.
The red indicator blinks
The orange indicator
blinks
Character Input
Only capital letters are
being input
How to input European
characters (ß, à, ç), sym-
bols or Euro Currency
Symbol is unclear
Setup Utility
[Enter Password] is dis-
played
[Advanced] menu can
not be registered
All or some items in [Se-
curity] menu can not be
registered
F9 does not work
[Hard Disk Lock] is not
displayed
Application Software
Computer hangs
Use the Windows password as the following.
Select [Start] - [Settings] - [Control Panel] - [Power Management]* - [Advanced], then
add the check mark for [Prompt for password when computer goes off standby].
* Windows 2000: [Power Options]
The battery level is low. Save your data and power off your computer.
After connecting the AC adaptor or replacing the battery pack with a fully charged
one, turn your computer on.
The battery pack or recharging function may be defective. Quickly remove the
battery pack and disconnect the AC adaptor, then connect them again.
If the problem persists, contact Panasonic Technical Support.
Unable to charge because of an improper temperature range. (
tions")
If CapsLock is on, the Caps Lock function is ON. To switch it OFF, press
Caps Lock .
Windows 98 Windows 2000
Select [Start] - [Programs] - [Accessories] - [System Tools] - [Character Map].
The Character Map will be displayed. Point to the desired font name and select it.
Windows NT
Select [Start] - [Programs] - [Accessories] - [Character Map]. The Character Map will
be displayed. Point to the desired font name and select it.
Enter the User Password or Supervisor Password. If you have forgotten it, contact
Panasonic Technical Support.
Restart the Setup Utility with the Supervisor Password.
Restart the Setup Utility with the Supervisor Password.
Restart the Setup Utility with the Supervisor Password.
The internal battery maintaining the clock may need to be replaced. Contact Pana-
sonic Technical Support.
Press Ctrl + Alt + Del , select [Shut Down], and then press [OK].
After shutting down by pressing the power switch for more than four seconds,
press the power switch to power on and open the application again.
If the program no longer operates normally, go to [Start] - [Settings] - [Control
Panel] - [Add/Remove Programs] to delete the program. Then reinstall the pro-
gram.
55
"Precau-