Assembly/Mounting - Central Pneumatic 67708 Set Up And Operating Instructions Manual

assembly/mounting

Bolt (64)
Wheel (63)
Bolts (71)
Tank (70)
Handle (72)
Bolts (71)
Figure 2
1. Attach the Wheels to the Tank, using the
Bolts and Hex Nuts.
2. Slide the Handle into the two slots on the
top of the Tank and secure in place with
four Bolts.
Figure 3
3. Thread the Air Filter onto the side of the
Cylinder Head.
4. Break in the new Air Compressor as
follows:
a. Make sure the Power Switch is OFF
and the unit is unplugged. Insert a
male coupler (sold separately) into the
SKU 67708
Wheel (63)
Bolt (64)
Cylinder Head (7)
Air Filter
(6)
For technical questions, please call 1-800-444-3353.
female Quick Coupler and fully open all
regulators and valves.
b. Plug in the Power Cord.
c. Turn the Power Switch ON.
d. Let the unit run for 30 minutes. Air will
Hex
expel freely through the Coupler.
Nuts
(65)
e. Turn the Power Switch OFF.
f. Unplug the Power Cord and remove the
male coupler.
5. Connect a regulator valve, an inline shut
off valve and a 1/4" NPT air hose to the
Quick Coupler (all sold separately). The
air hose must be long enough to reach
the work area with enough extra length
to allow free movement while working.
note: an in-line shutoff ball valve is an
important safety device because it
controls the air supply even if the air
hose is ruptured. the shutoff valve
should be a ball valve because it can
be closed quickly.
tool
Shut
off
Valve
Quick
coupler
6. Depending on the tool which you will
be using with this compressor, you
may need to incorporate additional
components, such as an in-line oiler,
a filter, or a dryer (all sold separately).
coupler
Plug
Quick
coupler
oiler Filter
regulator with
Pressure Gauge
Sample air line Setup
coupler
Plug
air Hose
on reel
air
compressor
Page 9