Set DVB channel manually [Manual Tuning]
Normally use [Auto Setup] or [Update Channel List] to retune DVB channels.
If tuning has not been done completely or for adjusting the direction of the aerial, use this function.
•
All channels found will be added to the Channel List.
DVB-C :
1
Enter the frequency
DVB-C Manual Tuning
Frequency
4
74,00 MHz
Symbol Rate
Auto
Service ID
Auto
Start scan
Signal Quality
Signal Strength
No.
Channel Name
Free TV: 0
Pay TV: 0
Stopped
DVB-T :
1
Adjust frequency for each channel
DVB-T Manual Tuning
Frequency
[CH21]
Signal Quality
Signal Strength
No.
Channel Name
Free TV: 0
Pay TV: 0
Radio: 0
Stopped
Update DVB channel automatically [Update Channel List]
You can add new channels, delete removed channels, update channel name and position automatically to Channel List.
DVB-T Update Channel List
Progress
CH 5
This will take about 3 minutes.
CH
Channel Name
Free TV: 0
Pay TV: 0
Searching
Display a notification message [New Channel Message]
Selects whether to give a notification message when a new DVB channel is found. [Off] / [On]
New channels found!
Press OK to update channel list.
Press EXIT to ignore.
Check DVB signal [Signal Condition]
Selects a channel and checks the DVB signal condition.
A good Signal Strength is not an indication of suitable signal for DVB reception.
Please use the Signal Quality indicator as follows :
[Signal Quality] :
•
Green bar
Good
•
Yellow bar
Poor
•
Red bar
Bad (Check the Terrestrial aerial or cable)
Example :
DVB-C Signal Condition
Channel Name
70 CBBC Channel
Signal Quality
Signal Strength
Bit Error Rate
0.00E+00
Wenvoe
Network Name
Parameter
802,00 MHz, 64 QAM, 6940 kS/s
Reduce the DVB-C signal [Attenuator]
If the DVB-C signal is too strong, the interference may occur. In this case set to [On] to reduce the signal automatically.
•
This function is available only for DVB-C signal.
abc
def
ghi
jkl
mno
pqrs
tuv
wxyz
•
100 %
Normally set [Symbol Rate] and
100 %
Type
New
[Service ID] to [Auto].
Radio: 0
474,00 MHz
100
%
100 %
•
Type
New
Set where the level of [Signal Quality]
becomes the maximum.
Data: 0
•
Channel List is updated while keeping your settings in [Favourites Edit],
69
[Channel List], [Child Lock], etc.
•
Depending on the signal condition, the update may not work properly.
Type
Quality
Radio: 0
•
Selecting OK will perform [Update Channel List].
These bars show the maximum signal value of the selected channel.
90
%
80
%
select channel
adjust frequency
2
Select [Start scan]
select
access
2
Search
•
To change the channel
41