Panasonic Viera TX-L32E31B Operating Instructions Manual page 13

■
[Wired]
3
1. Select [Auto]
Acquire IP Address
Auto
select
access
2. Go to the next step
(Press twice)
■
[Wireless]
Select the connection type
Connection Type
Please select network connection type.
Search for access point
WPS(Push button)
[Search for access point]
Access points found automatically are listed.
1. Select your desired access point
Available Access Points
No. SSID Wireless type
1 Access Point A 11n(2.4GHz)
2 Access Point B 11n(5GHz)
3 Access Point C 11n(5GHz)
•
To search access points again
(yellow)
2. Access the encryption key input mode
Encryption Key Setting
Connection will be made with the following settings:-
SSID : Access Point A
Authentication type : WPA-PSK
Encryption type : TKIP
Please input the encryption key.
Encryption key
3. Enter the encryption key of the access point
Access Point Settings
Encryption key
A B C D E F G H I
U V W X Y Z 0 1
a b c d e f g h i
u v w x y z ( ) +
4. Select [Yes]
Access Point Settings
Encryption key is set to:-
XXXXXXXX
Select 'Yes' to confirm.
Select 'No' to change.
Yes
Manual
Automatically setup is done and the test of the network
connection starts.
•
4
To set manually, select [Manual] and set each item. For
details (p. 73)
Encrypt Reception
•
For the information of the
highlighted access point
•
If the selected access point is not encrypted, the confirmation screen
will be displayed. It is recommended to select the encrypted access
point.
Set characters
J K L M N O P Q R S T
2 3 4 5 6 7 8 9 ! : #
j k l m n o p q r s t
- . * _
•
You can set characters by using numeric buttons.
•
To re-enter the encryption key, select [No].
•
If the connection has failed, check the encryption key, settings
No
and positions of your access point. And then, follow the on screen
instructions.
Connection Test
Check network cable connection.
Check acquired IP address.
Check for devices using same IP address.
Check gateway connection.
Check server connection for VIERA Connect.
select
access
select
access
: Encrypted access point
select
set
"Characters table for numeric buttons" (p. 96)
select
set
: succeeded
The test is successful
and the TV is connected
to the network.
: failed
Check the settings and
connections, and then
select [Retry].
•
To set manually (p. 76)
(red)
Store
BACK/
RETURN
13