Get Started - Philips SHD9200 User Manual

3 Get Started

Note
•
Before using the headphones for the first time, charge
the supplied batteries for at least 8 hours. Only
rechargeable NiMH batteries can be charged. Use the
batteries (capacity over 700mAh) to ensure the 20
hours' operating time from fully charged.
•
AAA alkaline batteries can be used to operate the
headphones.
•
Use Philips power adaptor only.
•
If no audio input for over 10 minutes, the transmitter
automatically turns to standby.
•
The docking station does not transmit audio signal
during charge.
•
Digital input only supports PCM (pulse code
modulation).
1
Install/Replace the supplied batteries (Fig.B).
2
Power on the transmitter (Fig.C).
3
Power off the headphones and charge the
headphones (Fig.D).
4
Press INPUT to select ANALOGUE or
DIGITAL mode (Fig.E).
In ANALOGUE mode, connect the audio
•
device to LINE IN sockets, then adjust
ATT (Attenuation of audio input signal)
(Fig.F).
• For portable CD player, MP3 player
or other devices with 3.5mm triport
socket output, connect with RCA to
RCA cable (provided) and RCA to
3.5mm plug adaptor (not provided),
then switch ATT to 0dB.
• For Hi-Fi, TV, DVD player or other
devices with RCA socket output,
connect with RCA to RCA cable
(provided), then switch ATT to -8dB.
• In DIGITAL mode, connect the digital
audio device to DIGITAL IN COAXIAL
socket with coaxial cable (not provided)
(Fig.G).
1
Press and hold
for 2 seconds to power on the
headphones (Fig.H).
2
Touch +/- on the right headphone to
adjust the volume (Fig.I).
3
Press the 3D SOUND button on the right
headphone to activate/deactivate the 3D
sound function (Fig.I).
» The LED on the transmitter turns on.
Tip
•
You can also adjust the volume on the audio device.
on the right headphone
EN 5