Table of Contents
Advertisement
Items supplied
• Wok with heat insulated handles
• Thermo-plinth with temperature controller
• Glass lid
• Heat-insulated lid handle with mounting materials
• removable drip grill
• 2 wooden spatulas, 1 wooden spoon, a pair of
chopsticks
• Operating manual
Description
1 Lid handle
2 Glass lid
3 Wok
4 Heat insulated handles
5 Power cable
6 Heating coil
7 Thermo-plinth
8 Temperature regulator
9 Control lamp
Accessory:
0 Drip grill
q 2 wooden Spatulas
w Wooden spoon
e Chopsticks
Placement
Place the switched-on Wok exclusively on level, firm
and heat-resistant surfaces in a dry environment.
Important!
To avoid the risks of heat damage and fire in the
area adjacent to the switched on Wok, always
ensure that ...
• the switched-on Wok is at all times located at a
minimum distance of 50 cm from walls, furniture
and other objects.
• no objects are suspended above the switched-on
Wok (e.g. lamps).
• there are no easily inflammable objects close to
the switched-on Wok (e.g. materials/textiles).
• the power cable 5 and the thermo-plinth 7 are
not located close to hot surfaces or open flames.
• the power cable 5 does not, and cannot, make
contact with the thermo-sockel 7.
• no moisture and/or fluids can permeate into the
thermo-sockel 7. Non-compliance heightens the
risk of fire or of receiving an electrical shock!
Before the first use
Remove all components of the Electrical Wok from
the packaging. Remove all remaining protective
foils and clean the packaging/dust residues from
all components that will come into contact with
foodstuffs.
Do not use any abrasive cleaners or scouring pads,
these will destroy the non-stick surfaces of the Wok
3 and impair their effectiveness!
Mounting the lid handle
1. Place the lid handle 1 onto the broad insulating
wafer so that the rectangular retainer protudes
into the lid handle 1.
2. From above, lay the broad insulating wafer with
the lid handle 1 on the glass lid 2, so that the
holes lie one above the other.
3. Firstly, place the metallic washers over the screws.
Then place the rubber washers onto the screws
so that the broad sides lie flat against the metallic
washers.
4. From below, insert the screws with both washers
through the holes and then screw them tight with
a cross-head screwdriver.
- 4 -
Advertisement
Table of Contents
