Philips HTS3540 User Manual page 18

‡
Risk of electric shock. Never remove the
casing of the product.
To keep the warranty valid, never try to repair the
product yourself.
If you have problems using this product, check the
following points before you request service. If you
still have a problem, register your product and get
support at www.philips.com/welcome.
If you contact Philips, you will be asked for the
model and serial number of your product. The
model number and serial number are on the back
or bottom of your product. Write the numbers
here:
Model No. __________________________
Serial No. ___________________________
Disconnect the home theater from the
power outlet for a few minutes, then
reconnect.
Ensure that the TV is switched to the
correct source for this home theater.
If this happens when you change the TV
system, switch to its default mode: 1) Press
to open the disc compartment. 2) Press
the
Check if the HDMI cable is faulty. Replace
with a new HDMI cable.
If this happens when you change the HDMI
video resolution, switch to its default mode:
1) Press to open the disc compartment. 2)
Press the
Ensure that the audio cables are connected
and select the correct input source (for
example,
you want to play.
You might not hear any sound if the
connected device is not HDCP (High-
18
.
.
) for the device
bandwidth Digital Content Protection)
compliant or only DVI compatible. Use an
analog or digital audio connection.
Ensure that the
Connect an audio cable from the audio
input on the home theater to the audio
output on the TV, then press
repeatedly to select the correct
audio source.
Ensure that the TV volume is muted or set
to minimum if you are playing audio through
the home theater.
1) Press and hold
ZLWKLQ ÀYH VHFRQGV
Clean the disc.
Ensure that the home theater supports the
GLVF VHH ¶3URGXFW VSHFLÀFDWLRQV· RQ SDJH
14).
Ensure that the home theater supports the
region code of the DVD.
For DVD±RW or DVD±R, ensure that the
GLVF LV ÀQDOL]HG
(QVXUH WKDW WKH 'LY; ÀOH LV HQFRGHG
DFFRUGLQJ WR WKH ¶+RPH 7KHDWHU 3URÀOH·
with the DivX encoder.
(QVXUH WKDW WKH 'LY; YLGHR ÀOH LV FRPSOHWH
(QVXUH WKDW WKH VXEWLWOH ÀOH QDPH LV WKH
VDPH DV WKH PRYLH ÀOH QDPH
Select the correct character set: 1) Press
. 2) Select
3) Select
supported character set. 5) Press
Ensure that the format of the USB storage
device is compatible with the home theater
VHH ¶3URGXFW VSHFLÀFDWLRQV· RQ SDJH  
Ensure that the USB storage device
LV IRUPDWWHG ZLWK D ÀOH V\VWHP WKDW LV
supported by the home theater (note that
NTFS is not supported).
The operation is not possible.
is enabled.
. 2) Press
.
. 4) Select a
.