Advertisement
EnGlISh
Introduction
Congratulations on your purchase and welcome to Philips! To fully benefit from the
support that Philips offers, register your product at www.philips.com/welcome.
This TRESemmé Philips appliance is designed and created to give you the salon styles
you want, in a quick and easy way. We hope you enjoy using this TRESemmé Philips
styler.
General description (Fig. 1)
A Nano-Diamond ceramic coated plates
B
Power-on light
C Temperature wheel
D On/off slide switch
E
Hanging loop
Important
Read this user manual carefully before you use the appliance and save it for future
reference.
Danger
-
Keep the appliance away from water. Do not use it near or over water contained
in baths, washbasins, sinks etc. When you use the appliance in a bathroom, unplug
it after use. The proximity of water presents a risk, even when the appliance is
switched off.
Warning
-
Check if the voltage indicated on the appliance corresponds to the local mains
voltage before you connect the appliance.
-
Check the condition of the mains cord regularly. Do not use the appliance if the
plug, the mains cord or the appliance itself is damaged.
-
If the mains cord is damaged, you must have it replaced by Philips, a service
centre authorised by Philips or similarly qualified persons in order to avoid a
hazard.
-
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
-
Children should be supervised to ensure that they do not play with the
appliance.
-
Keep the appliance away from non-heat-resistant surfaces and never cover the
appliance with anything (e.g. a towel or clothing) when it is hot.
-
Keep the appliance away from flammable items.
-
Never leave the appliance unattended when it is connected to the mains.
Caution
-
For additional protection, we advise you to install a residual current device
(RCD) in the electrical circuit that supplies the bathroom. This RCD must have
a rated residual operating current not higher than 30mA. Ask your installer for
advice.
-
The straightening plates and the plastic parts near the plates reach a high
temperature quickly. Prevent the hot surfaces of the appliance from coming into
contact with your skin.
-
The maximum temperature occurs just after heating up. The actual temperature
during use may be lower.
-
Always unplug the appliance after use.
-
Wait until the appliance has cooled down before you store it.
-
Always switch off the appliance before you put it down, even if it is only for a
moment.
-
Do not wind the mains cord round the appliance.
-
Only use the appliance on dry hair.
-
Do not use the appliance on artificial hair.
-
Do not use the appliance for any other purpose than described in this manual.
-
Do not leave the plates in your hair for more than a few seconds at a time as
this may cause damage to your hair.
-
Keep the straightening plates clean and free of dust, dirt and styling products
such as mousse, spray and gel. Dust, dirt and styling products may cause damage
to the nano-diamond ceramic coated straightening plates.
-
The straightening plates have a nano-diamond ceramic coating. This
coating slowly wears away over time. This does not affect the performance of the
appliance.
-
If you use the appliance on colour-treated hair, the straightening plates may stain.
Electromagnetic fields (EMF)
This Philips appliance complies with all standards regarding electromagnetic fields
(EMF). If handled properly and according to the instructions in this user manual, the
appliance is safe to use based on scientific evidence available today.
Using the appliance
Straighteners are powerful styling tools and must always be used with care.
As with all straighteners that reach salon-high temperatures, do not use the appliance
frequently to avoid damage to the hair. If you use the straightener incorrectly or if you
use it at the wrong temperature setting, you could overheat your hair or even burn it.
Always make sure you select a temperature setting that is suitable for your hair type.
A
2
Straightening
1
Put the plug in the wall socket.
2
Set the on/off switch to 'I'.
The green power-on light goes on.
,
Never leave the appliance unattended when it is plugged in. Always put the
appliance on a heat-resistant surface when it is heating up and when it is hot.
3
Turn the temperature wheel to select the required temperature setting (the
thicker the line on the temperature wheel, the higher the setting). Select
a temperature setting that is suitable for your hair type. (Fig. 2)
-
Always select a low setting when you use the straightener for the first time.
-
For coarse, curly or hard-to-straighten hair, select a medium to high setting.
-
For fine, medium-textured or softly waved hair, select a low to medium setting.
Take extra care with pale, blonde, bleached or colour-treated hair, since it is
susceptible to damage at high temperature settings.
4
Let the appliance heat up for at least 30 seconds.
5
Comb or brush your hair so that it is disentangled and smooth. (Fig. 3)
Use a comb to divide the hair into sections. Do not put too much hair in one section.
Tip: It is better to section off the crown area and to straighten the hair underneath first,
followed by the top area.
6
Take a section that is not wider than 5cm. Place it between the straightening
plates and press the handles of the appliance firmly together.
7
Slide the straightener down the length of the hair in 5 seconds, from root to
hair end, without stopping to prevent overheating (Fig. 4).
8
Repeat this process after 20 seconds until you have achieved the desired look.
9
Let your hair cool down. Do not comb or brush it before it has cooled down,
as this would ruin the hairstyle you have just created.
E
B C D
3
4
1
5
Advertisement
