Makita 6935FD Instruction Manual page 7

ASSEMBLY
1 2
1. Bit
2. Sleeve
1 2
1. Bit
2. Bit-piece
3. Sleeve
CAUTION:
• Always be sure that the tool is switched off and the battery cartridge is
removed before carrying out any work on the tool.
Installing or removing driver bit or socket bit
004521
Use only the driver bit or socket bit shown in the figure. Do not use any other
driver bit or socket bit.
For European and North & South American countries, Australia and New
Zealand
A=12mm
B=9mm
For other countries
A=17mm
B=14mm
A=12mm
B=9mm
1. To install the bit, pull the sleeve in the direction of the arrow and insert
001267
the bit into the sleeve as far as it will go. Then release the sleeve to
secure the bit.
2. To install the bit, pull the sleeve in the direction of the arrow and insert
004347
the bit-piece and bit into the sleeve as far as it will go. The bit-piece
should be inserted into the sleeve with its pointed end facing in. Then
release the sleeve to secure the bit.
To remove the bit, pull the sleeve in the direction of the arrow and pull the bit
out firmly.
NOTE:
3
• If the bit is not inserted deep enough into the sleeve, the sleeve will not
return to its original position and the bit will not be secured. In this case,
try re-inserting the bit according to the instructions above.
Use only these type of bit. Follow the procedure (1).
(Note) Bit-piece is not necessary.
To install these types of bits, follow the procedure (1).
(Note) Makita bits are these types.
To install these types of bits, follow the procedure (2).
(Note) Bit-piece is necessary for installing the bit.
006348
006349
7