Philips DVDR3600 User Manaul page 61

Picture
No picture
The picture is black and
white or distorted.
There is picture or sound
interference with the TV
reception.
Unable to display JPEG
pictures.
DVDR3600_75_UM_En_29791.indd 61 DVDR3600_75_UM_En_29791.indd 61
• Check the video connections. See chapter 'Connect'.
• Turn on the TV to the Video In channel.
• Use the TV remote control to select the channel until you see
the DVD screen. See chapter 'Get Started'.
• Your DVD recorder might have been set to progressive scan
mode while your TV does not support progressive scan. Follow
the steps below:
1) Connect the supplied AV cable (red/white/yellow) from the
CVBS OUTPUT jacks on the rear panel of the DVD recorder
to the TV's Video In and Audio In jacks.
2) Turn on the TV and use the TV's remote control to select
the corresponding video-in channel on the TV (eg., AV, EXT1,
EXT2).
3) Turn on the DVD recorder and wait until the TV displays
the recorder screen. Turn off progressive scan using the setup
menu. See chapter "Adjust settings – Video settings – Set
progressive scan".
• The disc does not match with the TV colour system standard
(PAL/NTSC).
• The disc is dirty, clean the disc.
• At times, some picture distortion may occur. This is not a
malfunction.
• If you have connected the recorder to a HDMI TV:
- Check if your TV supports the selected HDMI video
resolution. Select a lower HDMI video resolution. (See chapter
"Adjust settings - Setup HDMI video and audio).
- Change to a better quality HDMI cable (e.g. Category 2 cable).
• Check the connection to the antenna or cable TV signal.
• Fine-tune your TV channel. Read chapter 'Adjust settings -
Adjust HDMI video and audio'.
• This unit only supports pictures in JPEG-Exif fi le format with a
resolution not exceeding 4096 x 4096 (horizontal/vertical).
JPEG pictures that are downloaded from the internet or have
been modifi ed using the computer may not be displayed
properly.
EN
61
2008-02-15 4:36:49 PM 2008-02-15 4:36:49 PM