For Your Guidance; Specifications - Panasonic TX-32DK2 Operating Instructions Manual

FOR YOUR GUIDANCE

H Service
Before requesting service, please refer to the troubleshooting
guide on previous page to determine the symptoms. To obtain
service please contact your local Panasonic dealer quoting the
model number and serial number (both are located at the rear of
the TV).
H TV Games / Home Computers
Extended use of TV games or home computers with any television
set can cause a permanent 'shadow' on the screen. This type of
irreversible picture tube damage, can be limited by observing the
following points:
D Reduce the brightness and contrast levels to a minimum
viewing level.
D Do not operate the television set for a continuous period of
time while using TV games or home computers.
D This type of picture tube damage, is not an operating
defect, and as such is not covered by the Panasonic
warranty.

SPECIFICATIONS

Power Source
Power Consumption
Standby Consumption
Picture Tube
Visible Diagonal
Audio Output
Music Power
Dimensions
Weight (Kg)
Receiving
Systems/ Systems/
Band name
Aerial - - Rear
Headphones - - Front
AV - - Rear
Dolby Surround Out - - Rear
AV - - Front
Specifications are subject to change without notice. Weight and dimensions shown are approximate.
Dolby, Pro Logic and the
Manufactured under license from Dolby Laboratories.
44
Front Left / Right 20W x 2, External Centre 20W, 3D Subwoofer 26W
H
W
D
PAL I
PAL 525/60 PAL 525/60
M.NTSC
NTSC (AV input only)
AV2 -- 21 pin terminal -- Audio / Video in/out, S--Video in, Q--Link
External Speaker connections -- 2 x Rear, 1 x Centre, 1 x 3D Subwoofer
are trademarks of Dolby Laboratories.
H Last Position Memory
Certain functions have a last position memory, i.e. the setting at
the time of switch--off will be the setting used when the receiver is
switched on again:--
Programme
Headphone volume
AV Position
Volume
NICAM
Bass
Treble
Balance
Colour Balance
Status
Teletext mode
Surround mode
Speaker distance
H Sleep Feature
If the set is not switched off when the TV station stops
transmitting , it will automatically go to standby mode after 30
minutes. This function will not operate when the TV is in AV
mode.
TX- -32DK2
220 -- 240V 50Hz A.C.
130W
1.4W
76 cm
Surround 15W x 2, 8Ω impedance
561 mm
896 mm
558 mm
46
UHF E21--68
Playback of NTSC tape from some PAL Video recorders (VCR) Playback of NTSC tape from some PAL Video recorders (VCR)
Playback from M.NTSC Videorecorders (VCR)
Playback from NTSC Videorecorders (VCR)
UHF
3.5mm, 8Ω impedance
AV1 -- 21 pin terminal -- Audio / Video in / out, RGB in
5 x Dolby Surround Out RCA
AV3 -- S ---Video in, RCA Audio / Video in
Tint (M.NTSC / NTSC only)
Volume correction (in AV mode only)
Contrast
Sharpness
Aspect mode
Standby
Artificial Intelligence (AI)
Colour
Brightness
P--NR
Decoder (AV2)
Speaker level setting
Geomagnetic correction