Fax – Sending; Fax – Receiving - Panasonic KX-FL613FX Operating Instructions Manual

8. Help
8.3.3 Fax – sending
Problem
I cannot send documents.
I cannot send a fax
overseas.
The other party complains
that letters on their
received document are
distorted or not clear.
The other party complains
that black lines, white
lines or smudges appear
on their received
document.
8.3.4 Fax – receiving
Problem
I cannot receive
documents.
I cannot receive
documents automatically.
The display shows
"CONNECTING.....", but
faxes are not received.
A blank sheet is ejected.
52
Cause & Solution
L The telephone line cord is connected to the [EXT] jack on the unit.
Connect to the [LINE] jack (page 16).
L The other party's fax machine is busy or has run out of recording
paper. Try again.
L The other party's machine is not a fax machine. Check with the
other party.
L The other party's fax machine failed to answer the fax
automatically. Send the fax manually (page 27).
L Use the overseas transmission mode (feature #23 on page 43).
L Add two pauses at the end of the telephone number or dial
manually.
L If your line has special telephone services such as call waiting, the
service may have been activated during fax transmission. Connect
the unit to a line that does not have these services.
L Another telephone on the same line is off the hook. Hang up the
extension telephone and try again.
L Try copying the document. If the copied image is clear, there may
be something wrong with the other party's machine.
L The glass or rollers are dirty with correction fluid, etc. Clean them
(page 61). Please do not insert a document before correction fluid
has dried completely.
Cause & Solution
L When you have a single telephone line and subscribe to a voice
mail service, you must also subscribe to a Distinctive Ring service
(page 37).
L The telephone line cord is connected to the [EXT] jack on the unit.
Connect to the [LINE] jack (page 16).
L The receiving mode is set to TEL mode. Set to FAX ONLY mode
(page 33) or TEL/FAX mode (page 33).
L The time taken to answer the call is too long. Decrease the number
of rings before the unit answers a call (feature #06 on page 42 and
#78 on page 45).
L The incoming call is not a fax. Change the receiving mode to TEL
mode or TEL/FAX mode (page 33).
L The other party placed the document in their fax machine the
wrong way. Check with the other party.