Panasonic KX-TGA681E Installation Manual page 4

Installation
Charge for about 7 hours.
R When the batteries are fully charged, "Fully charged" is displayed.
Note:
R The handset display may show "Please wait for 1 minute." when the
handset is placed on the charger if it is not registered to the base unit.
R If the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends (
charge again.
Registering the handset to the base unit
Ensure that the handset is switched on. If it is not on, press and hold MeN for
few seconds to turn the handset on.
1
Handset:
Lift the handset and press MeN.
2
Base unit:
Press and hold M
R Depending on the base unit, a registration tone sounds.
R If all registered handsets start ringing, press M
3
Handset:
Place the handset on the base unit or charger.
R Continue the operation even when the handset display shows "Please
4
With the handset still on the base unit or charger, wait until a confirmation tone
sounds and
4
TGA681E(en-en)_1220_ver011.pdf
Rechargeable Ni-MH
ONLY
,
N for about 5 seconds.
this step.
wait for 1 minute.".
is displayed.
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
4
) and the charge contacts with a dry cloth and
N again to stop, then repeat
Confirm "Charging"
is displayed.
2012/12/20 19:20:07