Table of Contents
Advertisement
Special maintenance
The oven may require special
maintenance or replacement of
parts subject to wear such as seals,
bulbs, etc. The following instructions
describe how to carry out these minor
maintenance operations.
Before any intervention that requires
access to live parts, disconnect the
appliance from the power supply.
Replacing the light bulb
WARNING
Ensure that the appliance is
disconnected from the power supply
before replacing the lamp, to avoid
the possibility of electric shock.
If a light bulb needs to be replaced
because it is worn or burnt out, remove
the guide frames; see "page 40 EN,
Removing guide frames".
Then carefully remove the bulb cover
using a suitable tool (e.g. a flat bladed
screwdriver).
Remove the bulb by sliding it out as
shown.
The bulbs are halogen, so do not touch
them directly with your fingers, wrap
them in an insulating material.
Replace the bulb with one of the same
type G9 Halogen (40 W / 230 V).
Replace the cover correctly, so that the
moulded part of the glass is facing the
door.
„ Note
Press the cover down as far as it will
go so that it attaches completely to
the bulb support.
44
EN
- Quick Links:
- Instructions for Use
Hide quick links:
Advertisement
Table of Contents
