How To Use The Remote Control; Using The Unit With Optional Accessories; Using The Unit With An Audio System - Panasonic SL-SW860 Operating Instructions Manual

Anti-Shock Function
Anti-shock works by reading audio data and storing it in
memory (up to 40 seconds worth). The unit then fills in
interruptions caused by bumps and vibrations with data
from the memory. This unit also incorporates a powerful
anti-shock mechanism that prevents skipping caused
when play speed is changed by swinging of the unit.
Press during play or stop mode.
A.SHOCK
G
The following indicator appears on the display panel.
After about
20 seconds
A.SHOCK A.SHOCK
The jogger indicator
starts flashing.
Using Stereo Headphones with Remote Control
The remote control can be operated regardless of the
HOLD mode of the unit.
Preparation: Release the remote control from the
HOLD mode.
Play/stop/off button
[VOL]
∫ Operation confirmation tones
When an operation button is pressed, a confirmation
tone sounds. Refer to the parentheses in the illustra-
tion for the different types of confirmation tones.

Using the Unit with Optional Accessories

Using the unit with an audio system

Using a stereo connection cable (not included), you can
listen to CDs through your audio system.
≥Connect the cable to the amplifier after turning off its
power.
≥Do not connect the cable to the PHONO jacks on the
amplifier.
≥Obtain the optional connecting cable if the amplifier
comes with mini-phone jacks.
≥Adjust the volume level on the amplifier.
SL-SW880 ONLY
You can connect speakers, active or otherwise, with an
impedance of 1k≠ or less to the headphone jack. Set
the unit's volume between 5 and 8.
Note.
Sound quality changes when S-XBS or VMSS
(SL-SW880 only) is selected, but volume is reduced
by approximately fifty percent.
OUT jack
Side panel of the unit
(White)
(Red)
Stereo connection cable (not included)
5
Note!
Wait until the jogger indicator appears before starting to
jog.
When bumps continue repeatedly
The message "SORRY" appears on the display and
sound is interrupted.
The jogger indicator can also flash or go out under
the following conditions:
≥As the end of the last track approaches.
About
≥As the end of a track approaches during random play, pro-
5 seconds later
gram play, and 1 track repeat play.
≥If the track in play or next track is extremely short.
A.SHOCK
To cancel the anti-shock function
Press [A.SHOCK] again.

How to use the remote control

To start play
[j]
[i]
To stop play
HOLD
To turn off
the unit
Using the unit with a car audio
system
SL-SW861C comes with a car adaptor and car stereo
cassette adaptor.
Items to be purchased
(SL-SW880/SL-SW860)
For connection to the car audio system:
Car stereo cassette adaptor (SH-CDM10A)
Connect the car stereo cassette adaptor
to the unit's headphone jack.
(When doing this, keep the unit's VOLUME
control at a setting between 5 and 8.)
For securing the unit and connecting the
power supply:
≥Car adaptor (SH-CDC9)
≥Car mounting kit (SH-CDF20)
Note.
It may not be possible to use the unit with some types of
car stereo owing to restrictions imposed by the con-
struction of the car stereo cassette adaptor.
Amplifier
For further details, refer to the instructions of the part
L
concerned.
To CD or AUX
terminals
R
A.SHOCK
Press once during off or stop mode.
(Beep)
Press once during play.
(Beep...Beep)
Press and hold during play or stop mode.
(Beep...Bee...p)
Note!
≥The anti-shock setting can be changed during play,
but this may cause a slight interruption in the sound
because the disc's rotational speed changes.
≥During anti-shock operation, the disc rotates at a high-
er rate than usual in collecting extra audio data. This
could result in a slight increase in disc rotation noise.
Listening to sound with the unit con-
nected to an audio system
The anti-shock function uses digital signal compression
technology. It is recommended that the anti-shock func-
tion be canceled if the unit is connected to a home
audio system.
SL-SW880 ONLY
Press once during play.
Backward
Skipping
(Beep Beep
tracks
Beep)
Seaching
through tracks
Press and hold during play.
To adjust the
volume
[VOL] on the remote control adjusts volume
only. To adjust the VMSS effect, use
[VOLUME] on the main unit.
Maintaining the
Lens
Open the lid and clean the lens as shown in the figure.
Use a cotton swab to gently wipe off any finger-prints.
Recommended product: Lens cleaner kit (SZZP1038C)
Air blower for
camera lens
Lens
Lens
To prevent the disc from being scratched or
damaged
Remove built up dust from the felt pads.
Felt pads
Forward
(Beep
Beep)
RQT5528