Miele KFN 8701 SE ed-1 Operating And Installation Instructions page 48

Installing in a side-by-side combination
^ Remove covers j from both
appliances.
^ Loosely attach large upper bracket
k using long screws l.
^ Push the two appliances together,
and align them again.
^ Now tighten the screws l.
^ Position wide brackets m at the top
and bottom on the back, and push
the top bracket upwards until it is in
the correct position (z).
^ Secure the brackets at the sides
using screws n.
To avoid vibrations, neither the
brackets nor the screws should
touch the pipework on the back of
the appliances.
48
^ Plug the two appliances into the
mains electricity supply points.
Appliances with integrated
ice-maker (depending on model):
Plumb the appliance into the mains
water supply.
^ Carefully push the two appliances
back into their final position. It is
easier if you raise the appliances at
the front, and roll them back on their
rear rollers.
The height of the appliances can be
aligned again if necessary.
^ Position the long stainless steel trim
o lightly in the gap, making sure that
it is located above bracket i.
^ Then push it carefully into the gap.
Use a soft cloth to do this to avoid
denting the trim.
^ Carefully remove the protective foil
from the stainless steel trim.