Makita 3710 Instruction Manual page 11

1
4
5
1. Wing nut
2. Guide plate
3. Straight guide
4. Center hole
5. Bolt
1. Nail
2. Center hole
3. Straight guide
1
2
3
4
1. Clamp screw (A)
2. Adjusting screw
3. Clamp screw (B)
4. Trimmer guide
5. Wing bolt
For cutting circles between 121 mm and 221 mm in radius.
006620
NOTE:
• Circles between 172 mm and 186 mm in radius cannot be cut using this
guide.
2
3
Align the center hole in the straight guide with the center of the circle to be cut.
006637
Drive a nail less than 6 mm in diameter into the center hole to secure the
straight guide. Pivot the tool around the nail in clockwise direction.
1
2
3
Trimmer guide
006648
Trimming, curved cuts in veneers for furniture and the like can be done easily
with the trimmer guide. The guide roller rides the curve and assures a fine cut.
Loosen the wing bolts and secure the tool base horizontally. Install the trimmer
006638
guide on the tool base with the clamp screw (A). Loosen the clamp screw (B)
and adjust the distance between the bit and the trimmer guide by turning the
adjusting screw (1 mm per turn). At the desired distance, tighten the clamp
screw (B) to secure the trimmer guide in place.
5
11