Pc Input Terminals Connection - Panasonic TH-37PG9B Operating Instructions Manual

PC Input Terminals connection

Notes:
• Due to space limitations, occasionally you may have trouble connecting Mini D-sub 15P cable with ferrite core to PC input
Terminal.
• Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning
frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)
• The display resolution is a maximum of 640 × 480 dots (TH-37PG9B, TH-42PG9B when the aspect mode is set to
"4:3", and 852 × 480 dots (TH-37PG9B, TH-42PG9B) when the aspect mode is set to "16:9". If the display resolution
exceeds these maximums, it may not be possible to show fi ne detail with suffi cient clarity.
• The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible, you
will need to make setting changes to the computer at the time of connection.
• Some PC models cannot be connected to the set.
• There is no need to use an adapter for computers with DOS/V compatible Mini D-sub 15P terminal.
• The computer shown in the illustration is for example purposes only.
• Additional equipment and cables shown are not supplied with this set.
• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specifi ed
frequency range.
• To use sync input VBS signals, use the connector which incorporates a 75-ohm termination resistance and which is
available on the market, for the connection of the HD connector where the VBS signals are to be input.
Signal Names for Mini D-sub 15P Connector
11 12 13 14 15
6 7 8 9 10
1 2 3 4 5
Pin Layout for PC Input
Terminal
COMPUTER
Conversion adapter
(if necessary)
Connect a cable which matches
the audio output terminal on the computer.
Pin No. Signal Name
R (P /C
1
R
G (Y)
2
B (P /C
3
B
NC (not connected)
4
GND (Ground)
5
RGB
PC cable
Audio
Pin No. Signal Name
) GND (Ground)
6
R
GND (Ground)
7
) GND (Ground)
8
B
NC (not connected)
9
GND (Ground)
10
Connections
AUDIO
PC IN
Mini D-sub 15p
Stereo plug
Pin No. Signal Name
NC (not connected)
11
SDA
12
HD/SYNC
13
VD
14
SCL
15
9