Select The Input Signal; Selecting The On-Screen Menu Language - Panasonic TH-42PW6 Operating Instructions Manual

Select the input signal

- VOL +
R - STANDBY INPUT MENU ENTER
G POWER ON
- +
INPUT MENU VOL ENTER
INPUT
SURROUND
VOL
N R

Selecting the On-Screen Menu Language

INPUT
SURROUND
VOL
N R
PICTURE SOUND SET UP
MULTI
Power On/Off and input signal selection
INPUT
Select the input signals to be connected by installing the optional
Terminal Boards.
Input signals will change as follows:
INPUT1
When a SCART terminal installed, S VIDEO input is switched with the
INPUT button.
(Example) If a SCART terminal is installed in the Slot1 input.
[If Input Label is VIDEO 1, and RGB input is at Input 1]
RGB1
[If Input Label is VIDEO 1, and there is no RGB input at Input 1]
Video1
Notes:
(1) Input terminal will not be selected if the terminal board is not
installed into the SLOT.
(2) Select to macth the signals from the source connected to the
component/RGB input terminals. (see page 30)
(3) In 2 screen display, the same input mode cannot be selected for
the main picture and sub picture.
SET UP
Press to display the Set Up menu.
Selectable languages
English(UK)
Deutsch
Français
Italiano
ENGLISH(US)
Press the INPUT button to select the input signal to be
played back from the equipment which has been
connected to the Plasma Display.
INPUT2 INPUT3
INPUT2 INPUT3
S Video INPUT3
Press to select the OSD Language.
Press to select your
preferred language.
Español
....... (Chinese)
PC IN
PC IN
PC IN
Setup
Component/RGB-in select
RGB
Input label RGB1
Signal
Screensaver
Power save Off
Standby save On
Off
Power management
English ( UK )
OSD Language
1/2
13