Advertisement
Height Adjustment
The Remote Controller may be placed adjacent to a
taller System Controller. Height adjustment is available
as shown below to match the panel surface to the other
controller. Skip these steps when the Remote Controller
is used without another controller.
1
Place the controller upside down.
2
Remove 2 screws on the bottom and another 2 on the
rear.
3
Move the bottom cover upward about 12 mm (a half
inch).
4
Fix the bottom cover with the removed 4 screws as
shown.
Specifications
Power Required:
Current Consumption:
Interface:
Operating Temperature:
Dimensions:
Weight:
[Height] in brackets indicate the value is obtained after the height adjustment.
Weight and dimensions indicated are approximate.
Specifications are subject to change without notice.
Standard Accessory
Modular Cable (20 m, 65 ft 7 inch) ............................... 1 pc.
2000
© Matsushita Communication Industrial Co., Ltd. All rights reserved.
DC 5 V (supplied from WJ-HD500 Digital Disk Recorder)
170 mA
2-Wire Serial Communication, Modular Jack (RJ-11)
+5°C to +45°C (41°F to 113°F)
140 mm (W) x 75 [87.5] mm (H) x 177 mm (D), rubber feet exclusive
5-1/2" x 2-15/16" [3-7/16] x 6-15/16"
800 g (1.8 lbs)
Matsushita Electric Industrial Co., Ltd.
Central P.O. Box 288, Osaka 530-91, Japan
Bottom Cover
NM0900-1110
V8QA5601BN
N 19
Printed in Japan
Advertisement
