Specifi Cations; Faqs - Panasonic Viera TH-42PZ70E Operating Instructions Manual

FAQs

Problem
Chaotic image, noisy
No image can be
displayed
Blurry or distorted image
(no sound or low volume)
Unusual image is displayed
No sound is produced
Sound level is low
or sound is distorted
Whirling sound is heard
•
Due to the digital reception technologies involved, quality of the DTV signals may be relatively low in
some cases, despite good reception of analogue programmes.
Unable to receive signals
with a high-performance
aerial
Interference or
frozen / disappearing
image in DVB
Sound is unusual
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
TV goes into
"Standby mode"
The remote control
does not work
46
Actions
•
Set "P-NR" in the Picture Menu (to remove noise). (p. 22)
•
Check nearby electrical products
(car, motorcycle, fl uorescent lamp).
•
Is "Colour" or "Contrast" in the Picture Menu set to the minimum?
(p. 22)
•
Check Colour system. (p. 29)
•
Reset channels. (p. 29)
•
Turn off the TV with Mains power On / Off switch, then turn it on
again.
•
Is "Sound mute" active? (p. 9)
•
Is the volume set to the minimum?
•
Sound signal reception may be deteriorated.
•
Set "MPX" (p. 22) in the Sound Menu to "Mono". (Analogue)
•
Check Sound system. (p. 29)
•
The sound is from built-in cooling fan
(not a sign of faulty operation).
•
Install an aerial individually for the TV and VCR
(or use a splitter).
TV
(Individual aerial)
Splitter
Aerial Output
Aerial
Input
Aerial Input
terminal
Aerial Output
VCR
(Individual aerial)
•
Check "DVB Signal Condition". (p. 30)
If "Signal Quality" or "Signal Strength" are displayed in red, check
aerial.
If problem persists, consult your local Panasonic dealer.
•
Turn the TV off with the Mains power On / Off switch, then turn it
On again.
•
Set the sound setting of the connected equipment to
• "2ch L.PCM".
Check the "HDMI1 Input" setting in the Sound Menu. (p. 22)
•
If digital sound connection has a problem, select analogue sound
connection. (p. 37)
•
Is the HDMI cable connected properly? (p. 40)
•
Turn Off the TV and equipment, then turn them On again.
•
Check an input signal from the equipment. (p. 44)
•
Use an equipment compliant with EIA/CEA-861/861B.
•
• Off Timer function is activated.
The TV enters "Standby mode" about 30 min. after broadcasting
ends.
•
• Are the batteries installed correctly? (p. 6)
Has the TV been switched On?
Specifi cations
TH-42PZ70EA, TH-42PZ70E
Power Source AC 220-240 V, 50 / 60 Hz
Average use 494 W
0.5 W (Without DVB recording)
Standby condition
20 W (With DVB recording)
Aspect Ratio 16:9
106 cm (diagonal)
Visible screen size
922 mm (W) × 518 mm (H)
Number of pixels 2,073,600 (1,920 (W) × 1,080 (H)) [5,760 × 1,080 dots]
160 mm × 42 mm × 2 pcs, 8 Ω
Speaker
Audio Output 20 W (10 W + 10 W), 10% THD
Headphones M3 (3.5 mm) stereo mini Jack × 1
VGA, SVGA, XGA
SXGA ······ (compressed)
PC signals
Horizontal scanning frequency 31 - 69 kHz
Vertical scanning frequency 59 - 86 Hz
PAL B, G, H, I, SECAM B, G, SECAM L / L'
VHF E2 - E12
VHF A - H (ITALY)
CATV (S01 - S05)
CATV S11 - S20 (U1 - U10)
PAL D, K, SECAM D, K
Receiving Systems /
VHF R1 - R2
Band name
VHF R6 - R12
PAL 525/60
DVB
M.NTSC
NTSC (AV input only) Playback from NTSC Video recorders (VCR)
•
TV signals may not be received in some areas.
Aerial - Rear VHF / UHF
Temperature : 0 °C - 35 °C
Operating Conditions
Humidity : 20 % - 80 % RH (non-condensing)
AV1 (Scart terminal) 21 Pin terminal (Audio/Video in, Audio/Video out, RGB in, Q-Link)
AV2 (Scart terminal) 21 Pin terminal (Audio/Video in, Audio/Video out, RGB in, S-Video in, Q-Link)
VIDEO RCA PIN Type × 1
AV3 S-VIDEO Mini DIN 4-pin
AUDIO L - R RCA PIN Type × 2
Y
VIDEO
P , P
COMPONENT
B R
AUDIO L - R RCA PIN Type × 2
HDMI1 / 2 TYPE A Connectors
HIGH-DENSITY D-SUB 15PIN
Others PC
Card slot SD CARD slot × 1
Output AUDIO L - R RCA PIN Type × 2
1,134 mm × 688 mm × 330 mm (With Pedestal)
Dimensions ( W × H × D )
1,134 mm × 641 mm × 116 mm (TV only)
42.0 k Net (With Pedestal)
Mass
35.0 k Net (TV only)
Note
•
Design and Specifi cations are subject to change without notice. Weight and Dimensions shown are approximate.
•
This equipment complies with the EMC standards listed below.
EN55013, EN61000-3-2, EN61000-3-3, EN55020, EN55022, EN55024.
TH-50PZ70E
569 W
127 cm (diagonal)
1,106 mm (W) × 622 mm (H)
VHF H1 - H2 (ITALY)
UHF E21 - E69
CATV S1 - S10 (M1 - M10)
CATV S21 - S41 (Hyperband)
VHF R3 - R5
UHF E21 - E69
Playback of NTSC tape from some PAL Video re cord ers (VCR)
Digital terrestrial services via VHF / UHF aerial input.
Playback from M. NTSC Video recorders (VCR)
1.0 V[p-p] (75 Ω)
Y:1.0 V[p-p] (75 Ω) C:0.286 V[p-p] (75 Ω)
0.5 V[rms]
1.0 V[p-p] (including synchronization)
±0.35 V[p-p]
0.5 V[rms]
•
This TV supports "HDAVI Control 2" function.
R,G,B/0.7 V[p-p] (75 Ω)
HD, VD/TTL Level 2.0 - 5.0 V[p-p] (high impedance)
0.5 V[rms] (high impedance)
1,323 mm × 802 mm × 369 mm (With Pedestal)
1,323 mm × 754 mm × 99.5 mm (TV only)
50.5 k Net (With Pedestal)
43.0 k Net (TV only)
47