Specifi Cations; Faqs - Panasonic Viera TH-37PX7E Operating Instructions Manual

FAQs

Before requesting service or assistance, please follow these simple guides to resolve the problem.
If problem still persists, please contact your local Panasonic dealer for assistance.
White spots or shadow images (noise)
•
Check the position, direction, and connection of the aerial.
Neither image nor sound is produced
•
• Is the TV in "AV mode"?
• Is the mains lead plugged into the socket outlet?
• Is the TV turned On?
• Check Picture Menu (p. 22) and volume.
Check all required SCART cables and connections
are fi rmly in place.
Auto aspect
•
Auto aspect is designed to provide you with the
best aspect ratio to use to fi ll your screen. For user
control please see p. 40.
S-Video / black and white picture
•
Using AV button please confi rm your selection is
S-Video I.e. AV2/AV2S (p. 16).
To customer using indoor aerial
•
In order to enjoy a good quality DVB image, it is important
to receive a good quality DVB signal. For this purpose
check "DVB Signal Condition" in Tuning Menu (p. 30). A
level of at least 5 is required in order to provide a good
picture. It may be necessary to adjust the position and
direction of the aerial to achieve the best possible result.
Problem
Chaotic image, noisy
No image can be displayed
Blurry or distorted image
(no sound or low volume)
Unusual image is displayed
No sound is produced
Sound level is low
or sound is distorted
•
Due to the digital reception technologies involved, quality of the DTV signals may be relatively low in
some cases, despite good reception of analogue programmes.
Unable to receive signals
with a high-performance aerial
Interference or frozen /
disappearing image in DVB
42
On Screen messages - I.e. EC/AV1
•
You can simply clear these by pressing the button.
Press again to redisplay.
No DVB programmes shown after Auto Setup
•
Check the DVB transmitter.
•
Adjust the direction of the aerial to another
transmitter installed nearby.
•
Check the analogue broadcast. If the image quality is
poor, check the aerial and consult your nearest dealer.
An error message appears
•
• Follow the message's instructions.
If the problem persists, contact the authorized Service Centre.
Direct TV record / Q-Link functions not recording
•
Please confi rm SCART cable and connection. Also
please set "AV1 / AV2 out" in the Setup Menu (p. 23).
Permanently lit spots on screen
•
Due to production process involved in this technology this may result in
some pixels which are permanently lit or unlit. This is not a malfunction.
Contrast is reduced
•
Contrast is lowered when the following conditions
without any user operation for a few minutes:
● no signal in DVB or AV mode
● selected locked channel
● selected invalid channel
● selected radio channel
● displayed menu
Actions
•
• Set "P-NR" in the Picture Menu (to remove noise). (p. 22)
Check nearby electrical products (car, motorcycle, fl uorescent lamp).
•
Is "Colour" or "Contrast" in the Picture Menu set to the minimum? (p. 22)
•
Check Colour system. (p. 29)
•
Reset channels. (p. 29)
•
Turn off the TV with Mains power On / Off switch, then turn it on
again.
•
Is "Sound mute" active? (p. 9)
•
Is the volume set to the minimum?
•
• Sound signal reception may be deteriorated.
• Set "MPX" (p. 22) in the Sound Menu to "Mono". (Analogue)
Check Sound system. (p. 29)
•
Install an aerial individually for the TV and VCR
(or use a splitter).
TV
(Individual aerial)
Splitter
Aerial Output
Aerial
Input
Aerial Input
Aerial Output
terminal
VCR
(Individual aerial)
•
Check "DVB Signal Condition". (p. 30)
If "Signal Quality" or "Signal Strength" are displayed in red, check aerial.
• If problem persists, consult your local Panasonic dealer.
Turn the TV off with the Mains power On / Off switch, then turn it On again.
FAQs
Problem
Sound is unusual
Pictures from external equipment
are unusual when the equipment
is connected via HDMI
TV goes into "Standby mode"
The remote control does not work
Specifi cations
TH-37PX7E
Power Source AC 220-240 V, 50 / 60 Hz
Average use 250 W
0.7 W (Without DVB recording)
Standby condition
20 W (With DVB recording)
Aspect Ratio 16:9
94 cm (diagonal)
Visible screen size
819 mm (W) × 457 mm (H)
737,280 (1,024 (W) × 720 (H))
Number of pixels
[3,072 × 720 dots]
160 mm × 42 mm × 2 pcs, 8 Ω
Speaker
Audio Output 20 W (10 W + 10 W ), 10% THD
PAL B, G, H, I, SECAM B, G, SECAM L / L'
VHF E2 - E12
VHF A - H (ITALY)
CATV (S01 - S05)
CATV S11 - S20 (U1 - U10)
PAL D, K, SECAM D, K
Receiving Systems /
VHF R1 - R2
Band name
VHF R6 - R12
PAL 525/60
DVB
M.NTSC
NTSC (AV input only) Playback from NTSC Video recorders (VCR)
•
TV signals may not be received in some areas.
Aerial - Rear VHF / UHF
Temperature : 0 °C - 35 °C
Operating Conditions
Humidity : 20 % - 80 % RH (non-condensing)
AV1 (Scart terminal) 21 Pin terminal (Audio/Video in, Audio/Video out, RGB in, Q-Link)
AV2 (Scart terminal) 21 Pin terminal (Audio/Video in, Audio/Video out, RGB in, S-Video in, Q-Link)
HDMI TYPE A Connector
Y
VIDEO
P , P
COMPONENT
B R
AUDIO L - R RCA PIN Type × 2
AUDIO L - R RCA PIN Type × 2
Output
917 mm × 665 mm × 320 mm
(With Pedestal)
Dimensions ( W × H × D )
917 mm × 620 mm × 95 mm
(TV only)
25.0 k Net (With Pedestal)
Mass
23.0 k Net (TV only)
Note
•
Design and Specifi cations are subject to change without notice. Weight and Dimensions shown are approximate.
•
This equipment complies with the EMC standards listed below.
EN55013, EN61000-3-2, EN61000-3-3, EN55020.
Actions
•
Set the sound setting of the connected equipment to "2ch L.PCM".
•
• Check the "HDMI Input" setting in the Sound Menu. (p. 22)
If digital sound connection has a problem, select analogue sound
connection. (p. 35)
•
Is the HDMI cable connected properly? (p. 38)
•
• Turn Off the TV and equipment, then turn them On again.
Check an input signal from the equipment. (p. 41)
•
Use an equipment compliant with EIA/CEA-861/861B.
•
• Off Timer function is activated.
The TV enters "Standby mode" about 30 min.after broadcasting ends.
•
Are the batteries installed correctly? (p. 6)
•
Has the TV been switched On?
TH-42PX7E TH-50PX7E
270 W 370 W
0.5 W (Without DVB recording)
20 W (With DVB recording)
106 cm (diagonal) 127 cm (diagonal)
922 mm (W) × 518 mm (H) 1,106 mm (W) × 622 mm (H)
786,432 (1,024 (W) × 768 (H)) 1,049,088 (1,366 (W) × 768 (H))
[3,072 × 768 dots] [4,098 × 768 dots]
VHF H1 - H2 (ITALY)
UHF E21 - E69
CATV S1 - S10 (M1 - M10)
CATV S21 - S41 (Hyperband)
VHF R3 - R5
UHF E21 - E69
Playback of NTSC tape from some PAL Video re cord ers (VCR)
Digital terrestrial services via VHF / UHF aerial input.
Playback from M. NTSC Video recorders (VCR)
•
This TV supports "HDAVI Control 2" function.
1.0 V[p-p] (including synchronization)
±0.35 V[p-p]
0.5 V[rms]
0.5 V[rms] (high impedance)
1,020 mm × 725 mm × 320 mm 1,210 mm × 839 mm × 370 mm
(With Pedestal) (With Pedestal)
1,020 mm × 680 mm × 95 mm 1,210 mm × 793 mm × 95 mm
(TV only) (TV only)
28.0 k Net (With Pedestal) 39.0 k Net (With Pedestal)
26.0 k Net (TV only) 37.0 k Net (TV only)
43