Connections - Panasonic TH-32LHD7B Operating Instructions Manual

Connections

When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker's Installation Manual for details on speaker installation.
Speakers (Optional accessories)
SPEAKERS
Terminals (R)
– AC cord fi xing
1. Open the clamper.
Clamper
Note: The power plug in the illustration may not be the type fi tted to your set.
– Cable fi xing bands Secure any excess cables with bands as required.
Pass the attached cable
fi xing band through the
clip as shown in the
fi gure.
1
R
AV Terminals
(see page11)
Note: At factory shipment, Terminal boards are installed in SLOT 1 and SLOT 2.
8
R AUDIO L VIDEO IN VIDEO OUT R AUDIO L VD HD P R /C R /R P B /C B /B Y/G
IN
S VIDEO IN AV COMPONENT/RGB IN AUDIO
SLOT 1 SLOT 2 PC IN SERIAL
AC cord connection (see page 12)
2. Insert the AC cord and close
the clamper securely.
AC cord
To secure cables connected to Terminals, wrap the cable fi xing band around them
then pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
2
L
AUDIO VIDEO IN VIDEO OUT R
IN
AV
S VIDEO IN
SLOT1
COMPONENT/RGB IN
and Audio IN Terminals
(see page11)
SPEAKERS
Terminals (L)
3. Slide up the clamper
and fi x the AC cord
plug securely.
To tighten:
Pull
AUDIO L P /C /R P /C /B Y/G
R R B B
COMPONENT/RGB IN
SLOT2
From EXTERNAL
monitor terminal on
Computer (see page 9)
1
2
2
4. Insert the point of the
fi xed clamper into the
small hole on the lower
When loosen
the clamper:
To loosen:
Push the catch
AUDIO
PC IN SERIAL
From SERIAL Terminal
on Computer
(see page 10)
1
r i g h t o f
t h e b a c k
c o v e r a s
necessary.
Pull