Panasonic WJ-SX550A Operating Instructions Manual page 18

5. Preset Control
The preset function is used to memorize the setting points of focus, zoom, pan and tilt of a desired scene in advance, and to be
able to recall those setting points quickly, according to circumstance.
In addition, if the Camera Position Numbers are registered included the camera numbers with the preset positions in advance, and
to be able to recall those camera position quickly activating the camera selection and preset function at the same time.
This control is available with the Panasonic WV-CS500 or WV-CS600 Combination Camera, which enables the setting and recalling
of the Preset function from the System Controller.
6. Sequence
This system has three kinds of sequential modes: Program, Tour and Group
6-1. Program Sequence
The program sequence is a series of 64 steps assigned to a particular monitor. Each step can have a specific camera assigned to
it.
In the Program Sequence, each monitor has its own specified sequence operation as shown below.
P.SEQ 1
P.SEQ 2
P.SEQ 3
P.SEQ 4
Program Sequence
P.SEQ15
P.SEQ16
-15-
Monitor 1
Monitor 2
Monitor 3
Monitor 4
Monitor 15
Monitor 16
2