Table of Contents
Advertisement
7. Camera/Colour Bar Selector (CAM/BAR)
This selector is used to select either the video sig-
nal or the EBU colour bar signal which is output
from the video output connector (VIDEO), YC (S-
VIDEO) output connector or RGB (D-SUB, 9-pin)
output connector.
CAM :The video signal from the camera is output.
BAR : The EBU colour bar signal is output.
Set this switch to BAR when making video monitor
adjustments and recording the colour bar signal.
8. White Balance Selector (ATW/AWC/MANU)
This selector is used to select one of the following
white balance modes.
ATW : In this mode, the colour temperature is mon-
itored continuously and thereby white balance
is set automatically.
AWC : In this mode, accurate white balance is
obtained.
The white balance settings are as follows:
1. Aim the camera at a white chart.
2. Press the ITEM (AWC) button on the front
panel to set the white balance.
3. When the auto white balance is completed,
the auto warning indicator first blinks and
then goes off.
If the auto warning indicator remains lit, repeat
the above procedure for setting the auto white
balance.
MANU : The white balance can be adjusted manu-
ally with the red gain (R GAIN) and blue gain
controls (B GAIN).
9. Auto Warning Indicator
This indicator blinks while the white balance or
black balance is being automatically set. This indi-
cator lights continuously when the white balance or
black balance is set improperly. In this case, follow
the auto white balance or black balance setting
procedure.
10. Red and Blue Gain Controls (R GAIN/B GAIN)
These controls are used to manually adjust the
white balance.
These controls only work when the white balance
selection switch (ATW/AWC/MANU) is set to
MANU.
Turn the controls clockwise to increase the red and
blue
signal
levels,
decrease.
11. Page Button (PAGE)
This button is used to display the SETUP menu by
pressing it for 2 seconds or more, and to change
the parameters in the SETUP menu.
and
counterclockwise
to
12. Item Button (ITEM/AWC)
While the SETUP menu is displayed, this button is
used to move the cursor downward.
Normally, when the white balance selection switch
(ATW/AWC/MANU) is set to AWC, this button is
used to set the automatic white balance control
(AWC).
13. Left Button (A/ABC)
While the SETUP menu is displayed, this button is
used to move the cursor to the left.
Normally, this button is used to set the automatic
black balance control (ABC).
14. Right Button (B)
This button is used to move the cursor to the right
in the SETUP menu.
15. Scene File Selector (SCENE)
This selector is used to select the scene files.
16. Electronic Light Control ON/OFF Selector
(ELC ON/OFF)
This selector is used to select the electronic light
control mode as follows:
ON : Enables Electronic Light Control (ELC) mode
and disables Electronic Shutter Speed (SHUT-
TER) mode.
OFF : Enables Electronic Shutter Speed (SHUT-
TER) mode and disables Electronic Light
Control (ELC) mode.
Note :
Confirm the setting of the ELC and SHUTTER
parameters on the SETUP menu.
17. Electronic Shutter Speed Control (LEVEL)
This control is used to set the target value of the
Electronic Shutter Speed between 1/50 and
1/10 000 seconds together with the ELC ON/OFF
switch.
18. Title Input Connector (TITLE)
This connector is used to connect the optional
Character Generator WJ-KB30 or WJ-KB50.
Note :
The Black and White characters of the genera-
tor are mixed with the video signal and are
obtained at VIDEO OUT, S-VIDEO (Y/C) OUT
and RGB/SYNC OUT connectors.
Colourization of characters is not available.
-5-
Advertisement
Table of Contents
