Panasonic GP-US522CUE Operating Instruction page 16

M CIRCLE
(Medium Circle)
L CIRCLE
(Large Circle)
Note: Detection areas are not displayed on the
monitor.
3-1-1. Manual setting of the ELC detection control
area (MANU)
You can mask areas on the monitor screen to block the
strong brightness manually. Follow the steps below:
Note:
The manual mask setting field is only displayed on
VIDEO1, 2 and S-VIDEO OUT.
It is not displayed on RGB/SYNC output.
1. Move the cursor to the AREA parameter on the
ELC CONT menu.
2. Select MANU and press the PAGE button. The
manual mask setting field appears.
Cursor
(WHITE)
3. Select the area where backlight is bright by press-
ing A, B or the ITEM button.
Detection Area
Detection Area
4. Press the PAGE button to mask that area. The
mask turns white. (When the cursor is moved on an
area that has already been masked, the mask and
cursor start blinking.)
Masked Area
(WHITE)
Note: A masked area will be excluded from ELC
detection.
5. Repeat the steps 3 and 4 to complete masking.
To cancel masking, move the cursor to that area
and press the PAGE button.
Masked Area
(WHITE)
6. After masking is completed, press the PAGE button
for a second or more. The ELC CONT menu
appears.
3-1-2. Peak and Average Weight Control
(PEAK/AVE)
1. Move the cursor to the PEAK/AVE parameter. The
"I" cursor starts blinking.
** ELC CONT **
AREA
PEAK/AVE
RET
2. Move the "I" cursor to set the detection value.
When the "I" cursor is moved to the P (peak) side,
the peak value is detected.
When the "I" cursor is moved to the A (average)
side, the average value is detected.
-14-
ALL
P....I....A
END