Panasonic D-Snap SV-AV100 Operating Instructions Manual page 64

rëáåÖ=^ÅÅÉëëçêáÉë
ª Inserting the Button-type Battery
Before using the Remote Controller, insert the
supplied button-type battery.
N
While pressing the Stopper 1, pull out
the Battery Holder.
O
Insert the button-type battery with the
imprint (r) facing upward.
P
Insert the Battery Holder into the Remote
Controller.
≥When the button-type battery becomes weak,
replace it with a new CR2025 battery. (A battery
is normally expected to last about one year,
however, it depends on operation frequency.)
≥Be sure to match the poles properly when
inserting the battery.
Warning
"THE LITHIUM BATTERY IS A CRITICAL
COMPONENT (TYPE NUMBER CR2025
MANUFACTURED BY PANASONIC).
IT MUST NEVER BE SUBJECTED TO
EXCESSIVE HEAT OR DISCHARGE. IT MUST
THEREFORE ONLY BE FITTED IN EQUIPMENT
DESIGNED SPECIFICALLY FOR ITS USE.
REPLACEMENT BATTERIES MUST BE OF THE
SAME TYPE AND MANUFACTURER.
THEY MUST BE FITTED IN THE SAME MANNER
AND LOCATION AS THE ORIGINAL BATTERY,
WITH THE CORRECT POLARITY
CONNECTIONS OBSERVED.
DO NOT ATTEMPT TO RE-CHARGE THE OLD
BATTERY OR RE-USE IT FOR ANY OTHER
PURPOSE. IT SHOULD BE DISPOSED OF IN
WASTE PRODUCTS DESTINED FOR BURIAL
RATHER THAN INCINERATION."
SQ
N
OIP
1